Hummer H2. Manual — part 2623
Fig. 30: Disassembled View Of Shift Control Solenoids
Courtesy of GENERAL MOTORS CORP.
2004 Hummer H2
2003-04 AUTOMATIC TRANSMISSIONS Servicing - H2
Fig. 31: Removing 3-2 Control Solenoid & Retainer
Courtesy of GENERAL MOTORS CORP.
Installation
1. Install the 3-2 control solenoid. Install the 3-2 control solenoid retainer. Install the 1-2 and 2-3 shift
control solenoids. See Fig. 31 .
2. Install the 1-2 and 2-3 shift control solenoid retainers. Install the pressure control solenoid. Ensure the
electrical tabs are facing outboard. See Fig. 30 .
3. Install the pressure control solenoid retainer and retaining bolt and tighten to specification. See
TORQUE SPECIFICATIONS .
4. Connect the internal wiring harness electrical connectors to the following components:
z
Transmission fluid pressure switch. See Fig. 28 .
z
1-2 shift control solenoid.
z
2-3 shift control solenoid.
z
Pressure control solenoid.
z
TCC PWM solenoid.
z
3-2 control solenoid.
5. Install the 1-2 accumulator. See ACCUMULATOR ASSEMBLY .
2004 Hummer H2
2003-04 AUTOMATIC TRANSMISSIONS Servicing - H2
6. Install the transmission oil pan and filter. See DRAINING & REFILLING under LUBRICATION.
7. Fill transmission with appropriate fluid to proper level. See LUBRICATION .
EXTENSION HOUSING ASSEMBLY
Removal
1. Remove the drive shaft. See appropriate DRIVE SHAFTS & UNIVERSAL JOINTS article in
DRIVELINE/AXLES.
2. Remove the transmission mount. See TRANSMISSION MOUNT .
3. Support the transmission with a transmission jack.
4. Place a drain pan under the vehicle.
5. Remove the case extension bolts (1). See Fig. 32 .
6. Remove the case extension (2).
7. Remove and discard the case extension "O" ring seal (3).
Fig. 32: Removing & Installing Extension Housing
2004 Hummer H2
2003-04 AUTOMATIC TRANSMISSIONS Servicing - H2
Courtesy of GENERAL MOTORS CORP.
Installation
1. Install a new case extension "O" ring seal (3). See Fig. 32 .
2. Install the case extension (2).
3. Install the case extension bolts (1). Tighten the case extension bolts to specification. See TORQUE
SPECIFICATIONS .
4. Install the transmission mount. See TRANSMISSION MOUNT .
5. Remove the drain pan and the transmission jack.
6. Install the drive shaft. See appropriate DRIVE SHAFTS & UNIVERSAL JOINTS article in
DRIVELINE/AXLES.
7. Fill transmission with appropriate fluid to proper level. See LUBRICATION .
EXTENSION HOUSING REAR TRANSMISSION SEAL
Removal
1. Place a drain pan under the vehicle.
2. Remove the drive shaft. See appropriate DRIVE SHAFTS & UNIVERSAL JOINTS article in
DRIVELINE/AXLES.
3. Remove the rear extension transmission oil seal. See Fig. 33 .
4. Inspect the case extension housing for damage. Replace the extension housing if necessary.
NOTE:
Tools required: Rear Extension Seal Installer (J-21426), and Transmission
Assembly Lubricant (J-36850).
2004 Hummer H2
2003-04 AUTOMATIC TRANSMISSIONS Servicing - H2
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст