Hummer H2. Manual — part 2624
Fig. 33: Removing Rear Extension Housing Seal
Courtesy of GENERAL MOTORS CORP.
Installation
1. Lubricate the inside diameter of the NEW seal with Transjel(R) lubricant.
2. Install the new seal using rear extension seal installer and a soft faced mallet. See Fig. 34 .
3. Remove the drain pan.
4. Install the drive shaft. See appropriate DRIVE SHAFTS & UNIVERSAL JOINTS article in
DRIVELINE/AXLES.
5. Fill transmission with appropriate fluid to proper level. See LUBRICATION .
2004 Hummer H2
2003-04 AUTOMATIC TRANSMISSIONS Servicing - H2
Fig. 34: Installing Rear Extension Housing Rear Transmission Oil Seal
Courtesy of GENERAL MOTORS CORP.
FILLER TUBE & SEAL
Removal
1. Remove the transmission oil level indicator. Raise and suitably support the vehicle.
2. Remove frame-to-engine protection shield bolts. See Fig. 35 . Remove engine protection shield. Remove
the catalytic converter guard mounting bolts and guard from vehicle. See Fig. 36 .
3. Disconnect the connector position assurance (CPA) retainers. Disconnect the oxygen sensor electrical
connectors (1, 2). See Fig. 37 .
4. Remove the catalytic converter to muffler flange nuts. Remove the exhaust manifold pipe-to-catalytic
converter nuts. Remove the catalytic converter.
5. Remove the transmission heat shield bolt and shield. See Fig. 38 . Remove the nut securing the
transmission oil lever indicator tube to the transmission housing.
6. Place a drain pan under the vehicle. Remove the transmission oil level indicator tube from the
transmission case. See Fig. 39 . Remove the seal from the transmission case.
2004 Hummer H2
2003-04 AUTOMATIC TRANSMISSIONS Servicing - H2
Fig. 35: Identifying Frame-To-Engine Protection Shield
Courtesy of GENERAL MOTORS CORP.
2004 Hummer H2
2003-04 AUTOMATIC TRANSMISSIONS Servicing - H2
Fig. 36: Identifying Catalytic Converter Guard
Courtesy of GENERAL MOTORS CORP.
2004 Hummer H2
2003-04 AUTOMATIC TRANSMISSIONS Servicing - H2
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст