Hummer H2. Manual — part 1138
Fig. 51: Starter Lead Nut
Courtesy of GENERAL MOTORS CORP.
5. Install the starter lead (2) to the starter.
6. Install the starter lead nut (3).
Tighten: Tighten the starter lead nut to 3.4 N.m (30 lb in).
2004 Hummer H2
2004 ELECTRICAL Engine Electrical - Hummer H2
Fig. 52: Starter Bolts
Courtesy of GENERAL MOTORS CORP.
7. Position the starter into place.
8. Install the starter bolts.
2004 Hummer H2
2004 ELECTRICAL Engine Electrical - Hummer H2
Tighten: Tighten the starter bolts to 50 N.m (37 lb ft).
9. Connect the oil level sensor electrical connector.
Fig. 53: Transmission Cover Bolt
Courtesy of GENERAL MOTORS CORP.
10. Install the transmission cover bolt.
Tighten: Tighten the transmission cover bolt to 9 N.m (80 lb in).
11. Install the engine protective shield. Refer to Engine Protection Shield Replacement .
12. Lower the vehicle.
2004 Hummer H2
2004 ELECTRICAL Engine Electrical - Hummer H2
Fig. 54: Battery Ground Negative Cable & Bolt
Courtesy of GENERAL MOTORS CORP.
13. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure
(Single Battery) .
GENERATOR BRACKET REPLACEMENT
Removal Procedure
2004 Hummer H2
2004 ELECTRICAL Engine Electrical - Hummer H2
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст