Hummer H2. Manual — part 383
Fig. 38: I/P Compartment Door Hinge
Courtesy of GENERAL MOTORS CORP.
3. Remove the retaining screws to gain access to compartment handle.
4. Remove the compartment handle assembly.
Installation Procedure
1. Install new handle assembly to compartment door.
2. Ensure the linkage for the top compartment door are all connected before installing the inside panel.
3. Install the inside panel screws.
Tighten: Tighten the screws to 1.6 N.m (14 lb in).
4. Inspect the operation of the top compartment door
NOTE:
Refer to Fastener Notice in Cautions and Notices.
2004 Hummer H2
2004 ACCESSORIES & EQUIPMENT Instrument Panel, Gauges, and Console - Hummer H2
Fig. 39: I/P Compartment Door Hinge
Courtesy of GENERAL MOTORS CORP.
5. Install the compartment door to the I/P. Refer to Door Replacement - Instrument Panel (I/P)
Compartment .
INSTRUMENT PANEL (I/P) ASSIST HANDLE REPLACEMENT
Removal Procedure
2004 Hummer H2
2004 ACCESSORIES & EQUIPMENT Instrument Panel, Gauges, and Console - Hummer H2
Fig. 40: I/P Passenger Side Trim Panel
Courtesy of GENERAL MOTORS CORP.
1. Remove the passenger I/P (Instrument Panel) side trim panel.
2. Fully open the I/P storage compartment.
3. Using a long flat-bladed tool, through the opening in the I/P retainer (1) on the passenger side of the I/P:
1. Push in on the assist handle release button (2) and
IMPORTANT: Both the left and the right assist handle release buttons face the outside
of the vehicle. The release buttons need to be pushed towards the inside
of the vehicle to release the assist handle.
2004 Hummer H2
2004 ACCESSORIES & EQUIPMENT Instrument Panel, Gauges, and Console - Hummer H2
2. Pull out on the handle to partially disengage the assist handle.
4. Using a flat-bladed tool, through the I/P storage compartment opening, push in on the inboard assist
handle release button (3).
5. Remove the I/P assist handle.
Installation Procedure
Fig. 41: I/P Assist Handle
Courtesy of GENERAL MOTORS CORP.
1. Line assist handle with holes in I/P and push the I/P assist handle into the I/P until I/P assist handle clicks
into place.
2. Pull rearward on the assist handle to ensure the handle is secure.
3. Install the passenger side I/P side trim panel.
2004 Hummer H2
2004 ACCESSORIES & EQUIPMENT Instrument Panel, Gauges, and Console - Hummer H2
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст