Hummer H2. Manual — part 1210
4. Install the generator. Refer to Generator Replacement .
Fig. 58: Battery Cable Junction Block Bracket Bolts
Courtesy of GENERAL MOTORS CORP.
5. Install the battery cable junction block bracket bolts.
Tighten: Tighten the bolts to 9 N.m (80 lb in).
GENERATOR REPLACEMENT
Removal Procedure
CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
2004 Hummer H2
2004 ELECTRICAL Engine Electrical - Hummer H2
Fig. 59: Battery Ground Negative Cable & Bolt
Courtesy of GENERAL MOTORS CORP.
1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure
(Single Battery) .
2. Remove the accessory drive belt. Refer to Drive Belt Replacement - Accessory in Engine Mechanical -
6.0L (LQ4).
3. Remove the engine sight shield. Refer to Engine Sight Shield Replacement 6.0L (LQ4) in Engine
Mechanical - 6.0L (LQ4).
2004 Hummer H2
2004 ELECTRICAL Engine Electrical - Hummer H2
4. Disconnect the generator electrical connector.
Fig. 60: View Of Generator Cable & Nut
Courtesy of GENERAL MOTORS CORP.
5. Remove the generator cable from the generator, perform the following:
1. Slide the boot down revealing the terminal stud.
2. Remove the generator cable nut from the terminal stud.
3. Remove the generator cable.
2004 Hummer H2
2004 ELECTRICAL Engine Electrical - Hummer H2
Fig. 61: Generator Bolts
Courtesy of GENERAL MOTORS CORP.
6. Remove the generator bolts.
7. Remove the generator.
Installation Procedure
2004 Hummer H2
2004 ELECTRICAL Engine Electrical - Hummer H2
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст