Toyota Tundra. Manual — part 2479
Fig. 23: Identifying Turn Signal Flasher And Main Body ECU Connector Terminals
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
c. Measure the resistance according to the value(s) in the table below.
Standard resistance
TURN SIGNAL FLASHER - MAIN BODY ECU
NG: REPAIR OR REPLACE HARNESS OR CONNECTOR
OK: Go to next step
2. CHECK MAIN BODY ECU
a. Disconnect the J3 ECU connector.
Tester Connection
Condition Specified Condition
J29-S (DRL) - J3-8 (DRL)
Always
Below 1 ohms
J29-5 (DRL) - Body ground Always
10 kohms or higher
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Lighting - Tundra
Fig. 24: Identifying Main Body ECU Connector Terminals
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b. Measure the voltage according to the value(s) in the table below.
Standard voltage
MAIN BODY ECU
NG: REPLACE MAIN BODY ECU
OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS
TABLE
HEADLIGHT (HI-BEAM) CIRCUIT
DESCRIPTION
The main body ECU receives light control switch and dimmer switch information signals from the headlight
dimmer switch, and illuminates the headlight high beam.
WIRING DIAGRAM
Tester Connection
Switch Condition Specified Condition
J3-8 (DRL) - Body ground
Ignition switch ON
11 to 14 V
Ignition switch OFF
Below 1 V
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Lighting - Tundra
Fig. 25: Identifying Headlight (Hi-Beam) - Wiring Diagram
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
INSPECTION PROCEDURE
1. PERFORM ACTIVE TEST BY TECHSTREAM (HEADLIGHT)
a. Operate the Techstream according to the steps on the display and select "Active Test".
Techstream
Main Body
MAIN BODY - TECHSTREAM ACTIVE TEST CHART
OK: Headlight (High) turns on / off.
NG: Go to step 2
OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS
TABLE
2. INSPECT FUSE (HEAD LH, HEAD RH)
a. Remove the HEAD LH and HEAD RH fuse from the engine room junction block.
b. Measure the resistance according to the value(s) in the table below.
Standard resistance
Tester Display
Test Part
Control Range Diagnostic Note
Head Light (Hi) Headlight (High)
ON or OFF
-
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Lighting - Tundra
FUSE (HEAD LH, HEAD RH)
NG: REPLACE FUSE
OK: Go to next step
3. CHECK HARNESS AND CONNECTOR (HEADLIGHT HIGH BULB - BATTERY)
a. for LH:
1. Disconnect the A8 headlight connector.
Fig. 26: Identifying Headlight Connector Terminals - LH
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
2. Measure the voltage according to the value(s) in the table below.
Standard voltage
HEADLIGHT HIGH BULB - BATTERY LH
b. for RH:
1. Disconnect the A9 headlight connector.
Tester Connection Condition Specified Condition
HEAD LH fuse
Always
Below 1 ohms
HEAD RH fuse
Tester
Connection
Switch Condition
Specified
Condition
A8-2 - Body
ground
Light control switch HEAD, dimmer switch High
11 to 14 V
Light control switch HEAD, dimmer switch except
High
Below 1 V
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Lighting - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст