Toyota Tundra. Manual — part 2493
d. Measure the resistance according to the value(s) in the table below.
Standard resistance
FOOT LIGHT - MAIN BODY ECU AND BATTERY RESISTANCE
NG: REPAIR OR REPLACE HARNESS OR CONNECTOR
OK: REPLACE MAIN BODY ECU
6. INSPECT ROOM LIGHT SWITCH
a. Remove the room light switch (see REMOVAL ).
Fig. 79: Identifying Room Light Switch Connector Terminals
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b. Measure the resistance according to the value(s) in the table below.
Standard resistance
ROOM LIGHT SWITCH
NG: REPLACE ROOM LIGHT SWITCH (see REMOVAL )
OK: Go to next step
Tester Connection Condition Specified Condition
J51-2-DD-51 (ILE)
Always
Below 1 ohms
J51-2 - Body ground Always
10 kohms or higher
Tester Connection
Switch Condition
Specified Condition
5 (FCTY) - 10 (FLMP) Room light switch DOOR
Below 1 ohms
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Lighting - Tundra
7. INSPECT ROOF CONSOLE BOX ASSEMBLY
a. Remove the roof console box (see REMOVAL ).
Fig. 80: Identifying Roof Console Box Connector Terminals
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b. Roof console box switch is DOOR.
c. Connect the battery's positive (+) lead to terminal 2 (B) and the negative (-) lead to terminal 1
(CTY), and then check that the light turns on.
OK: Map light turns on.
NG: REPLACE ROOF CONSOLE BOX ASSEMBLY (see REMOVAL )
OK: Go to next step
8. CHECK HARNESS AND CONNECTOR (ROOF CONSOLE BOX - MAIN BODY ECU AND
BATTERY)
a. Disconnect the W7 box connector.
b. Disconnect the DD ECU connector.
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Lighting - Tundra
Fig. 81: Identifying Roof Console Box And Main Body ECU Connector Terminals
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
c. Measure the voltage according to the value(s) in the table below.
Standard voltage
ROOF CONSOLE BOX - MAIN BODY ECU AND BATTERY VOLTAGE
d. Measure the resistance according to the value(s) in the table below.
Standard resistance
ROOF CONSOLE BOX - MAIN BODY ECU AND BATTERY RESISTANCE
NG: REPAIR OR REPLACE HARNESS OR CONNECTOR
OK: REPLACE MAIN BODY ECU
CARGO LIGHT CIRCUIT
Tester Connection
Condition Specified Condition
W7-2 (B) - Body ground Always
11 to 14 V
Tester Connection
Switch Condition
Specified Condition
W7-1 (CTY) - DD-51 OLE) Room light switch DOOR
Below 1 ohms
W7-1 (CTY) - Body ground Room light switch DOOR 10 kohms or higher
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Lighting - Tundra
DESCRIPTION
The main body ECU receives a cargo light information signal from the cargo light switch and door courtesy
light switch, and illuminates the cargo light.
WIRING DIAGRAM
Fig. 82: Identifying Cargo Light - Wiring Diagram
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Lighting - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст