Toyota Tundra. Manual — part 1893
2
INSTALL CRANKSHAFT TIMING PULLEY
a
Align the timing pulley set key with the key groove of the pulley
b
Using SST and a hammer, tap in the timing pulley with the flange side facing inward
SST 09223-46011
Fig. 327: Tapping In Crankshaft Timing Pulley Using SST & Hammer
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
3
INSTALL TIMING BELT
a
Install the timing belt (see INSTALLATION )
4
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
REAR CRANKSHAFT OIL SEAL
COMPONENTS
NOTE:
Keep the lip free from foreign matter.
Do not tap the oil seal at an angle.
Fig. 326: Tapping In Oil Seal Using SST & Hammer
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
NOTE:
Some systems need to be initialized after the cable is reconnected (see
INITIALIZATION ).
2009 Toyota Tundra
2009 ENGINE Engine Mechanical (2UZ-FE) - Tundra
Fig. 328: Identifying Rear Crankshaft Oil Seal Replacement Components (1 Of 2)
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
2009 Toyota Tundra
2009 ENGINE Engine Mechanical (2UZ-FE) - Tundra
Fig. 329: Identifying Rear Crankshaft Oil Seal Replacement Components (2 Of 2) With Torque
Specifications
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
REMOVAL
1
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2
REMOVE AUTOMATIC TRANSMISSION ASSEMBLY
NOTE:
After the ignition switch is turned OFF, the navigation system
requires approximately 90 seconds to record various types of
memory and setting. As a result, after turning the ignition switch
OFF, wait 90 seconds or more before disconnecting the cable from
the negative (-) battery terminal.
Some systems need to be initialized after the cable is reconnected
(see INITIALIZATION ).
2009 Toyota Tundra
2009 ENGINE Engine Mechanical (2UZ-FE) - Tundra
a
for 2WD, refer to the following procedures (see REMOVAL )
b
for 4WD, refer to the following procedures (see REMOVAL )
3
REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (See REMOVAL )
4
REMOVE REAR CRANKSHAFT OIL SEAL
a
Using a knife, cut off the lip of the oil seal
b
Using a screwdriver, pry out the oil seal
HINT:
Tape the screwdriver tip before use
Fig. 330: Prying Out Oil Seal Using Screwdriver
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
INSTALLATION
1
INSTALL REAR CRANKSHAFT OIL SEAL
a
Apply MP grease to the lip of a new oil seal
b
Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer
edge
SST 09223-56010
NOTE:
Do not damage the surface of the oil seal press fit hole and
crankshaft.
NOTE:
Keep the lip free from foreign matter.
Do not tap on the oil seal at an angle.
2009 Toyota Tundra
2009 ENGINE Engine Mechanical (2UZ-FE) - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст