Toyota Tundra. Manual — part 2242
Fig. 286: Locating No. 1 Oil Pan Baffle Plate Bolts
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
51. REMOVE OIL STRAINER SUB-ASSEMBLY
a. Remove the 2 bolts, oil strainer and O-ring.
Fig. 287: Locating Oil Strainer Sub-Assembly Bolts
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
52. REMOVE ENGINE REAR OIL SEAL RETAINER
a. Remove the 6 bolts and oil seal retainer.
2009 Toyota Tundra
2009 ENGINE Engine Mechanical (3UR-FBE) - Tundra
Fig. 288: Locating Engine Rear Oil Seal Retainer Bolts
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b. Using a screwdriver, pry out the oil seal retainer.
HINT:
Tape the screwdriver tip before use.
Fig. 289: Prying Out Oil Seal Retainer
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
53. REMOVE OIL DRAIN PIPE SUB-ASSEMBLY
a. Remove the bolt and oil drain pipe.
Fig. 290: Locating Bolt And Oil Drain Pipe
2009 Toyota Tundra
2009 ENGINE Engine Mechanical (3UR-FBE) - Tundra
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b. Remove the O-ring.
54. REMOVE REAR CRANKSHAFT OIL SEAL
Fig. 291: Removing Rear Crankshaft Oil Seal
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
a. Place the oil seal retainer on wooden blocks.
b. Using a screwdriver and hammer, tap out the oil seal.
55. REMOVE RING PIN
56. REMOVE STUD BOLT
INSPECTION
1. INSPECT CYLINDER HEAD SET BOLT
a. Using a vernier caliper, measure the diameter of the elongated thread at the measuring point.
Standard diameter:
10.85 to 11.00 mm (0.427 to 0.433 in.)
Minimum diameter:
10.6 mm (0.417 in.)
If the diameter is less than the minimum, replace the cylinder head bolt.
HINT:
NOTE:
It is not necessary to remove the ring pin unless it is being replaced.
NOTE:
If the stud bolt is deformed or its threads are damaged, replace it.
2009 Toyota Tundra
2009 ENGINE Engine Mechanical (3UR-FBE) - Tundra
If a visual check reveals no excessively thin areas, check the center of the bolt (see illustration ) and
find the area that has the lowest diameter.
Fig. 292: Measuring Diameter Of Elongated Thread
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
2. INSPECT NO. 1 VALVE ROCKER ARM SUB-ASSEMBLY
a. Turn the roller by hand to check that it turns smoothly.
If the roller does not turn smoothly, replace the valve rocker arm.
Fig. 293: Turning Roller By Hand
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
3. INSPECT VALVE LASH ADJUSTER ASSEMBLY
NOTE:
Keep the adjuster free from dirt and foreign objects.
Use only clean engine oil.
2009 Toyota Tundra
2009 ENGINE Engine Mechanical (3UR-FBE) - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст