Toyota Tundra. Manual — part 1282
Fig. 312: Pushing Locks On Levers
b. Disconnect the 2 connectors.
Fig. 313: Disconnecting Connectors
c. Remove the 4 bolts and ECM.
Fig. 314: Locating Bolts & ECM
4. REMOVE ECM GASKET
a. Peel off the rubber part of the gasket.
NOTE:
Make sure that the lock lever is raised 90° as shown in the illustration
before disconnecting the ECM connectors. Failure to do this may
cause the ECM connectors to break.
2008 Toyota Tundra
2008 ENGINE PERFORMANCE Engine Control System (1GR-FE) - Tundra
Fig. 315: Peeling Off Rubber Part Of Gasket
b. Spray gasket remover or equivalent on the remaining tape of the gasket.
Fig. 316: Spraying Gasket Remover On Remaining Tape Of Gasket
c. Use a cutter knife to remove the tape of the gasket.
INSTALLATION
1. INSTALL ECM GASKET
a. Clean the ECM seal's surface with non-residue solvent.
b. Attach a new gasket to the ECM.
NOTE:
When using gasket remover or equivalent, cover the ECM connector
with a cloth.
NOTE:
Do not damage the ECM seal's surface with the knife.
2008 Toyota Tundra
2008 ENGINE PERFORMANCE Engine Control System (1GR-FE) - Tundra
Fig. 317: Using Cutter Knife To Tape Of Gasket
2. INSTALL ECM
a. Install the ECM with the 4 bolts.
Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
b. Connect the 2 ECM connectors and push each lock lever down to lock the ECM connectors.
NOTE:
Make sure the gasket is not folded or caught on any area on the
surrounding part.
Make sure there is no foreign matter caught between the gasket
and surrounding part.
Do not damage the gasket.
Fig. 318: Locating Bolts & ECM
NOTE:
Make sure that the lock lever is raised 90° before connecting the
ECM connectors. Failure to do this may cause the lock lever and
terminals to break.
Do not twist the wire harness when connecting the ECM
connectors.
2008 Toyota Tundra
2008 ENGINE PERFORMANCE Engine Control System (1GR-FE) - Tundra
3. CONNECT CONNECTOR HOLDER BLOCK
a. Connect the connector holder block with the 3 bolts.
Torque: 7.3 N*m (74 kgf*cm, 65 in.*lbf)
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Fig. 320: Locating Connector Holder Block & Bolts
ACCELERATOR PEDAL
COMPONENTS
Fig. 319: Connecting ECM Connectors
NOTE:
Some systems need to be initialized after the cable is reconnected (see
INITIALIZATION ).
2008 Toyota Tundra
2008 ENGINE PERFORMANCE Engine Control System (1GR-FE) - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст