Toyota Tundra. Manual — part 2355
Fig. 70: Inspecting Pull-In Coil
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b
Inspect the holding coil
1
Measure the resistance according to the value(s) in the table below
Standard resistance
MAGNETIC STARTER SWITCH ASSEMBLY (HOLDING COIL)
2009 Toyota Tundra
2009 ENG NE Starting (2UZ-FE) - Tundra
Fig. 71: Inspecting Holding Coil
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
If the result is not as specified, replace the magnet starter switch assembly
REASSEMBLY
Tester Connection
Condition Specified Condition
Terminal 50 - Switch body Always
Below 2 ohms
2009 Toyota Tundra
2009 ENG NE Starting (2UZ-FE) - Tundra
1
INSTALL STARTER ARMATURE ASSEMBLY
a
Install the starter armature to the starter yoke
2
INSTALL STARTER BRUSH HOLDER ASSEMBLY
a
Install a new O-ring to the groove of the starter yoke
b
Place the brush holder on the starter yoke
c
Using a screwdriver, hold the brush spring back
2009 Toyota Tundra
2009 ENG NE Starting (2UZ-FE) - Tundra
Fig. 72: Holding Brush Spring Back Using Screwdriver
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
d
Connect the brush to the brush holder
e
Connect the 4 brushes
f
Install 2 new O-rings and the end cover with the 2 screws
Torque: 3.8 N*m (39 kgf*cm, 34 in.*lbf)
g
Install the dust protector as shown in the illustration
NOTE:
Check that the positive (+) lead wires are not grounded.
2009 Toyota Tundra
2009 ENG NE Starting (2UZ-FE) - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст