Toyota Tundra. Manual — part 2179

5. INSTALL NO. 2 AIR CLEANER HOSE (see INSTALLATION )

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

7. ADD ENGINE COOLANT (See REPLACEMENT )

8. INSPECT FOR COOLANT LEAK (See ON-VEHICLE INSPECTION )

9. INSPECT FOR FUEL LEAK (See ON-VEHICLE INSPECTION )

10. INSTALL V-BANK COVER

a. Install the V-bank cover with the 2 nuts.

Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf)

Fig. 40: Identifying V-Bank Cover With Nuts
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

11. INSTALL FRONT COWL TOP OUTER PANEL SUB-ASSEMBLY

a. Install the front cowl top outer panel with the 7 bolts.

Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf)

NOTE:

Some systems need to be initialized after the cable is reconnected (see
INITIALIZATION ).

2009 Toyota Tundra

2009 ENGINE Intake (1GR-FE) - Tundra

Fig. 41: Identifying Front Cowl Top Outer Panel With Bolts
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

b. Connect the 2 washer hoses.

12. INSTALL FRONT WIPER MOTOR AND LINK ASSEMBLY

a. Install the front wiper motor and link (see INSTALLATION ).

13. INSTALL NO. 1 ENGINE UNDER COVER (See INSTALLATION )

VACUUM SWITCHING VALVE (FOR ACIS)

ON-VEHICLE INSPECTION

1. INSPECT VACUUM SWITCHING VALVE ASSEMBLY (for ACIS)

a. Disconnect the VSV connector.

b. Measure the resistance according to the value(s) in the table below.

Standard resistance

VACUUM SWITCHING VALVE ASSEMBLY (for ACIS) STANDARD RESISTANCE
SPECIFICATION

Tester Condition Condition Specified Condition

1 - 2

20°C (68°F)

37 to 44 ohms

1 - Body ground

Always

1 Mohms or higher

2 - Body ground

2009 Toyota Tundra

2009 ENGINE Intake (1GR-FE) - Tundra

Fig. 42: Inspecting Vacuum Switching Valve Assembly
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

If the result is not as specified, replace the VSV assembly.

c. Check the VSV operation.

1. When applying a vacuum to port E, check that air is sucked into the filter. If the result is not

as specified, replace the VSV assembly.

Fig. 43: Checking VSV Operation
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

2. Apply battery voltage across the terminals.

Fig. 44: Applying Battery Voltage Across Terminals
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

3. When applying a vacuum to port F, check that air is sucked into port E.

If the result is not as specified, replace the VSV assembly.

d. Connect the VSV connector.

AIR CLEANER

COMPONENTS

2009 Toyota Tundra

2009 ENGINE Intake (1GR-FE) - Tundra

Fig. 45: Identifying Air Cleaner Components With Torque Specifications
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

REMOVAL

1. REMOVE V-BANK COVER (see REMOVAL )

2. REMOVE NO. 2 AIR CLEANER HOSE

a. Loosen the hose clamp.

2009 Toyota Tundra

2009 ENGINE Intake (1GR-FE) - Tundra