Toyota Tundra. Manual — part 2929
Fig. 48: Removing Snap Ring
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b. Using SST and a press, press out the bearing.
SST 09555-55010
Fig. 49: Pressing Out Bearing Using SST
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
25. REMOVE TRANSFER LOW PLANETARY GEAR ASSEMBLY
a. Using a screwdriver, remove the snap ring.
b. Remove the transfer low planetary gear assembly and transfer low planetary gear spline piece from
the transfer input shaft.
NOTE:
Be careful not to drop or damage the low planetary gear.
2009 Toyota Tundra
2009 TRANSMISSION JF1A Transfer - Tundra
Fig. 50: Identifying Transfer Low Planetary Gear Assembly
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
26. REMOVE TRANSFER INPUT SHAFT PLUG
a. Using SST and a hammer, tap out the input shaft plug.
SST 09316-60011 (09316-00011)
Fig. 51: Tapping Out Input Shaft Plug
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
27. REMOVE NO. 1 TRANSFER OUTPUT SHAFT SPACER
a. Using 2 screwdrivers, tap out the snap ring. Then remove the output shaft spacer and front output
shaft needle roller bearing from the output shaft.
Fig. 52: Identifying No. 1 Transfer Output Shaft Spacer
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
28. REMOVE TRANSFER SYNCHROMESH SHIFTING KEY SPRING
a. Using a snap ring expander, remove the snap ring. Then remove the synchromesh shifting key
spring and synchromesh shifting key from the output shaft.
2009 Toyota Tundra
2009 TRANSMISSION JF1A Transfer - Tundra
Fig. 53: Identifying Transfer Synchromesh Shifting Key Spring
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
29. REMOVE TRANSFER CLUTCH HUB
a. Using a snap ring expander, remove the snap ring.
b. Using SST and a press, press out the clutch hub.
SST 09527-10011
Fig. 54: Pressing Out Clutch Hub Using SST
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
30. REMOVE REAR TRANSFER OUTPUT SHAFT RADIAL BALL BEARING
a. Using SST and a press, press out the bearing.
SST 09555-55010
b. Remove the drive sprocket and drive sprocket bearing.
c. Remove the synchronizer ring set.
NOTE:
Be careful not to drop or damage the output shaft.
NOTE:
Be careful not to drop or damage the output shaft.
2009 Toyota Tundra
2009 TRANSMISSION JF1A Transfer - Tundra
Fig. 55: Identifying Rear Transfer Output Shaft Radial Ball Bearing
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
31. REMOVE TRANSFER DRIVE CLUTCH HUB
a. Using 2 screwdrivers, tap out the snap ring.
Fig. 56: Tapping Out Snap Ring
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b. Using SST and a press, press out the drive clutch hub.
SST 09527-10011
Fig. 57: Pressing Out Drive Clutch Hub
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
c. Remove the 2 No. 1 synchromesh shifting key springs from the drive clutch hub.
2009 Toyota Tundra
2009 TRANSMISSION JF1A Transfer - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст