Toyota Tundra. Manual — part 1445
Fig. 268: Identifying R1 Canister Pump Module Connector
Result
RESULT REFERENCE
B : Go to step 31
A : Go to Next Step
20. INSPECT CANISTER PUMP MODULE (VENT VALVE OPERATION)
a. Turn the ignition switch off.
b. Disconnect the R1 canister pump module connector.
c. Apply the battery voltage to 9 (VLVB) and 8 (VGND) terminals of the canister pump module.
d. Touch the canister pump module to confirm the vent valve operation.
Test Result
Suspected Trouble Area
Proceed To
11 to 14 V
1. Wire harness between vent valve and ECM
2. Vent valve
3. ECM
A
Below 3 V Power source wire harness of vent valve
B
2008 Toyota Tundra
2008 ENGINE PERFORMANCE Engine Control System (2UZ-FE) - Tundra
Fig. 269: Identifying Terminal (VLVB) & (VGND) Of Canister Pump Module
Result
RESULT REFERENCE
B : Go to step 29
A : Go to Next Step
21. CHECK HARNESS AND CONNECTOR (ECM - CANISTER PUMP MODULE)
a. Disconnect the A24 ECM connector.
b. Disconnect the R1 canister pump module connector.
Test Result
Suspected Trouble Area
Proceed To
Operating
1. Wire harness between vent valve and ECM
2. ECM
A
Not operating Vent valve
B
2008 Toyota Tundra
2008 ENGINE PERFORMANCE Engine Control System (2UZ-FE) - Tundra
Fig. 270: Identifying A24 ECM & R1 Canister Pump Module Connectors
c. Measure the resistance between VPMP terminal of the ECM connector and VGND terminal of the
canister pump module connector.
Result
RESULT REFERENCE
A : Go to step 34
B : Go to step 31
22. PERFORM ACTIVE TEST USING TECHSTREAM (VACUUM PUMP (ALONE))
a. Turn the ignition switch off.
b. Disconnect the R1 canister pump module connector.
c. Turn the ignition switch to ON.
d. Enter the following menus: Powertrain/Engine and ECT/Active Test/Activate the Vacuum Pump.
e. Measure the voltage between MTRB terminal 1 of the canister pump module connector and the
body ground when the leak detection pump is turned ON and OFF using the Techstream.
Test Result
Suspected Trouble Area
Proceed To
Below 1 ohms
ECM
A
10 kohms or higher Wire harness between ECM and canister pump module
B
2008 Toyota Tundra
2008 ENGINE PERFORMANCE Engine Control System (2UZ-FE) - Tundra
Fig. 271: Identifying R1 Canister Pump Module Connector
Result
RESULT REFERENCE
B : Go to step 24
A : Go to Next Step
Test Result
Suspected Trouble Area
Proceed
To
Below 3 V when OFF
9 to 14 V when ON
1. Wire harness between leak detection pump and body
ground
2. Leak detection pump
A
Below 3 V when OFF and
ON
1. Wire harness between leak detection pump and
ECM
2. ECM
B
9 to 14 V when OFF and
ON
1. Wire harness between leak detection pump and
ECM
2. ECM
B
2008 Toyota Tundra
2008 ENGINE PERFORMANCE Engine Control System (2UZ-FE) - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст