Toyota Tundra. Manual — part 1444
Fig. 264: Identifying Hose To Intake Manifold From Purge VSV
Result
RESULT REFERENCE
B : Go to step 25
A : Go to Next Step
16. INSPECT PURGE VSV
a. Remove the purge VSV.
b. Apply the battery voltage to the terminals of the purge VSV.
c. Using an air gun, confirm that air flows from port A to port B.
Test Result
Suspected Trouble Area
Proceed To
Suction applied Purge line between purge VSV and intake manifold normal
A
No suction
Intake manifold port
Purge line between purge VSV and intake manifold
B
2008 Toyota Tundra
2008 ENGINE PERFORMANCE Engine Control System (2UZ-FE) - Tundra
Fig. 265: Applying Battery Voltage To Terminals Of Purge VSV
Result
RESULT REFERENCE
B : Go to step 30
A : Go to Next Step
17. CHECK HARNESS AND CONNECTOR (POWER SOURCE OF PURGE VSV)
a. Disconnect the D29 purge VSV connector.
b. Turn the ignition switch to ON.
c. Measure the voltage between terminal 2 of the purge VSV connector and the body ground.
Test Result Suspected Trouble Area Proceed To
Air flows
-
A
No air flow
Purge VSV
B
2008 Toyota Tundra
2008 ENGINE PERFORMANCE Engine Control System (2UZ-FE) - Tundra
Fig. 266: Identifying D29 Purge VSV Connector
Result
RESULT REFERENCE
B : Go to step 31
A : Go to Next Step
18. CHECK HARNESS AND CONNECTOR (PURGE VSV - ECM)
a. Disconnect the D74 ECM connector and the D29 purge VSV connectors.
b. Measure the resistance according to the value(s) in the table below.
Standard resistance
STANDARD RESISTANCE SPECIFICATION
OK : Go to step 34
NG : Go to step 31
Test Result
Suspected Trouble Area
Proceed To
11 to 14 V
Normal
A
Other than result above Wire harness or connectors between purge VSV and ECM
B
Tester Connection
Condition Specified Condition
D74-63 (PRG) - D29-1
Always
Below 1 ohms
D74-63 (PRG) - Body ground Always
10 kohms or higher
D29-2 - Body ground
Always
10 kohms or higher
2008 Toyota Tundra
2008 ENGINE PERFORMANCE Engine Control System (2UZ-FE) - Tundra
Fig. 267: Identifying D74 ECM & D29 Purge VSV Connectors
19. INSPECT CANISTER PUMP MODULE (POWER SOURCE FOR VENT VALVE)
a. Turn the ignition switch off.
b. Disconnect the R1 canister pump module connector.
c. Turn the ignition switch to ON.
d. Measure the voltage between VLVB terminal of the canister pump module connector and the body
ground.
2008 Toyota Tundra
2008 ENGINE PERFORMANCE Engine Control System (2UZ-FE) - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст