Toyota Tundra. Manual — part 613
Fig. 10: Front Power Seat Switch - Wiring Diagram (Driver Side)
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Seat - Tundra
Fig. 11: Front Power Seat Switch - Wiring Diagram (Passenger Side)
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
INSPECTION PROCEDURE
1. CHECK SEAT OPERATION
a. Operate the power seat switch and check that the front power seat operates.
Result
SEAT OPERATION
Result
Proceed to
Driver side power seat does not operate
A
Driver side lumbar does not operate
B
Driver side leg support does not operate
C
Passenger side power seat does not operate
D
Passenger side lumbar does not operate
E
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Seat - Tundra
B: Go to step 6
C: Go to step 10
D: Go to step 14
E: Go to step 18
A: Go to next step
2. INSPECT FUSE (ECU-B1, ECU-IG No. 1, FR P/SEAT)
a. Remove the ECU-B1 fuse from the engine room relay block.
b. Remove the FR P/SEAT LH and ECU-IG No. 1 fuses from the main body ECU.
c. Measure the resistance according to the value(s) in the table below.
Standard resistance
FUSE (ECU-B1, ECU-IG NO. 1, FR P/SEAT)
NG: REPLACE FUSE
OK: Go to next step
3. CHECK HARNESS AND CONNECTOR (FRONT POWER SEAT SWITCH LH - BATTERY
AND BODY GROUND)
a. Disconnect the Z9 and Z10 switch connectors.
b. Measure the voltage according to the value(s) in the table below.
Standard voltage
FRONT POWER SEAT SWITCH LH - BATTERY AND BODY GROUND VOLTAGE
SPECIFICATION
c. Measure the resistance according to the value(s) in the table below.
Tester Connection Condition Specified Condition
ECU-B1 fuse
Always
Below 1 ohms
ECU-IG No. 1 fuse
FR P/SEAT LH fuse
Tester Connection
Switch Condition Specified Condition
Z9-5 (+B) - Body ground
Always
11 to 14 V
Z10-4 (IG) - Body ground
Ignition switch OFF
Below 1 V
Ignition switch ON
11 to 14 V
Z10-8 (SYSB) - Body ground
Always
11 to 14 V
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Seat - Tundra
Standard resistance
FRONT POWER SEAT SWITCH LH - BATTERY AND BODY GROUND RESISTANCE
SPECIFICATION
Fig. 12: Identifying Front Power Seat Switch Connector Terminals
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
NG: REPAIR OR REPLACE HARNESS OR CONNECTOR
OK: Go to next step
4. INSPECT FRONT SEAT ADJUSTER ASSEMBLY LH
a. Disconnect the Z9 switch connector.
b. Apply battery voltage and check the operation of the power seat.
OK
FRONT SEAT ADJUSTER ASSEMBLY LH
Tester Connection
Condition Specified Condition
Z9-1 (GND) - Body ground Always
Below 1 ohms
Measurement Condition
Specified Condition
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Seat - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст