Toyota Tundra. Manual — part 366
Fig. 7: Identifying Waveform 1
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
f. Using an oscilloscope, check the waveform 2.
Waveform 2 (Reference);
ENGINE IMMOBILIZER SYSTEM WAVEFORM 2 REFERENCE
Fig. 8: Identifying Waveform 2
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
2. CHECK TRANSPONDER KEY ECU
Fig. 9: Identifying Transponder Key ECU Connector Terminals
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
Terminal No. (Symbols)
Tool Setting
Condition
J20-5 (TXCT) - J20-7 (AGND) 2 V/DIV., 20 msec./DIV. Key inserted in ignition key cylinder
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Engine Immobilizer - Tundra
a. Disconnect the J26 ECU connector.
b. Measure the resistance and voltage according to the value(s) in the table below.
TRANSPONDER KEY ECU TERMINALS RESISTANCE CHART DISCONNECT
If the result is not as specified, there may be a malfunction on the wire harness side.
c. Reconnect the J26 ECU connector.
d. Measure the resistance and voltage according to the value(s) in the table below.
TRANSPONDER KEY ECU TERMINALS RESISTANCE CHART RECONNECT
Terminal No.
(Symbols)
Wiring Color
Terminal
Description
Condition
Specified
Condition
J26-16(GND)-Body
ground
W-B - Body
ground
Ground
Always
Below 1 ohms
J26-1(+B) - J26-16
(GND)
G - W-B
Battery
Always
11 to 14 V
J26-2(IG) - J26-16
(GND)
GR - W-B
Ignition switch
Ignition switch OFF
Below 1 V
Ignition switch ON
11 to 14 V
J26-3(KSW) - J26-
16 (GND)
LG - W-B
Unlock warning
switch
No key in ignition key
cylinder
10 kohms or
higher
Key inserted in ignition
key cylinder
Below 1 ohms
Terminal No.
(Symbols)
Wiring
Color
Terminal Description
Condition
Specified Condition
J26-14(VC5) -
J26-16 (GND)
G - W-B
Power source
No key in ignition
key cylinder
Below 1 V
Key inserted in
ignition key
cylinder
4.6 to 5.4 V
J26-7(CTY) -
J26-16 (GND)
Y - W-B
Door courtesy
Door closed
10 kohms or higher
Door open
Below 1 ohms
J26-4(TXCT) -
J26-16 (GND)
L - W-B
Transponder key
amplifier communication
signal
No key in ignition
key cylinder
Below 1 V
Key inserted in
ignition key
cylinder
Pulse generation (see
step d, waveform 1)
J26-15(CODE) -
J26-16 (GND)
LG - W-
B
Transponder key
amplifier communication
signal
No key in ignition
key cylinder
Below 1 V
Key inserted in
ignition key
cylinder
Pulse generation (see
step e, waveform 2)
J26-13(EFIO) -
Y - W-B
ECM output signal
Ignition switch OFF
Below 1 V
Pulse generation (see
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Engine Immobilizer - Tundra
If the result is not as specified, the ECU may have a malfunction.
e. Using an oscilloscope, check the waveform 1.
Waveform 1 (Reference):
TRANSPONDER KEY ECU WAVEFORM 1 REFERENCE
Fig. 10: Identifying Waveform 1
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
f. Using an oscilloscope, check the waveform 2.
Waveform 2 (Reference):
TRANSPONDER KEY ECU WAVEFORM 2 REFERENCE
J26-16 (GND)
Ignition switch ON
step f, waveform 3)
J26-12(EFII) -
J26-16 (GND)
SB - W-
B
ECM input signal
Always
Pulse generation (see
step g, waveform 4)
J26-8(IND) -
J26-16 (GND)
V - W-B
Security indicator light
signal
Immobilizer set
status
Alternating between
11 to 14 V and below
1 V
Immobilizer unset
status
Below 1 V
J26-9(D) - J26-
16(GND)
L - W-B
Diagnosis tester
communication
Always
Pulse generation
Terminal No. (Symbols)
Tool Setting
Condition
J26-4(TXCT) - J26-16 (GND) 5 V/DIV., 20 msec./DIV. Key inserted in ignition key cylinder
Terminal No. (Symbols)
Tool Setting
Condition
J26-15(CODE) - J26-16 (GND) 5 V/DIV., 20 msec./DIV. Key inserted in ignition key cylinder
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Engine Immobilizer - Tundra
Fig. 11: Identifying Waveform 2
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
g. Using an oscilloscope, check the waveform 3.
Waveform 3 (Reference):
TRANSPONDER KEY ECU WAVEFORM 3 REFERENCE
Fig. 12: Identifying Waveform 3
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
h. Using an oscilloscope, check the waveform 4.
Waveform 4 (Reference):
TRANSPONDER KEY ECU WAVEFORM 4 REFERENCE
Terminal No. (Symbols)
Tool Setting
Condition
J26-13(EFIO) - J26-16 (GND) 10 V/DIV., 500 msec./ DIV. Ignition switch ON
Terminal No. (Symbols)
Tool Setting
Condition
J26-12(EFII) - J26-16 (GND) 12 V/DIV., 100 msec./ DIV. Always
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Engine Immobilizer - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст