Toyota Tundra. Manual — part 205
TESTER CONNECTION SPECIFIED CONDITION
NG: Go to step 2
Fig. 187: Identifying K3 Connector Terminals
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS
TABLE (see PROBLEM SYMPTOMS TABLE )
2. INSPECT STEERING PAD SWITCH ASSEMBLY
a. Disconnect the z3 switch connector.
b. Measure the resistance according to the values in the table below.
Tester Connection
Switch Condition
Specified Condition
K3-7 (SW1) - K3-6 (SWG)
No switch is pushed 100 kohms or higher
Seek+ switch: push
Below 1 ohms
Seek- switch: push
329 ohms
Volume+ switch: push
1000 ohms
Volume- switch: push
3100 ohms
K3-8 (SW2) - K3-6 (SWG)
No switch is pushed 100 kohms or higher
MODE switch: push
Below 1 ohms
On Hook switch: push
329 ohms
Off Hook switch: push
1000 ohms
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Audio/Visual - Tundra
Fig. 188: Inspecting Steering Pad Switch Assembly
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
Standard resistance
TESTER CONNECTION SPECIFIED CONDITION
NG: REPLACE STEERING PAD SWITCH ASSEMBLY (see REMOVAL )
OK: Go to next step.
3. INSPECT SPIRAL CABLE
a. Disconnect the z3 switch connector.
b. Disconnect the J45 cable connector.
c. Measure the resistance according to the value(s) in the table below.
Standard resistance
Tester Connection
Switch Condition
Specified Condition
z3-10 (AU1) - z3-8 (EAU)
No switch is pushed 100 kohms or higher
Seek+ switch: push
Below 1 ohms
Seek- switch: push
329 ohms
Volume+ switch: push
1000 ohms
Volume- switch: push
3110 ohms
z3-9 (AU2) - Z3-8 (EAU)
No switch is pushed 100 kohms or higher
MODE switch: push
Below 1 ohms
On Hook switch: push
329 ohms
Off Hook switch: push
1000 ohms
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Audio/Visual - Tundra
TESTER CONNECTION SPECIFIED CONDITION
Tester Connection
Condition
Specified
Condition
z3-8 (EAU) - J45-4
(EAU)
Spiral cable is turned 2.5 rotations
counterclockwise
Below 1 ohms
Spiral cable is centered
Spiral cable is turned 2.5 rotations clockwise
z3-10 (AU1) - J45-6
(AU1)
Spiral cable is turned 2.5 rotations
counterclockwise
Spiral cable is centered
Spiral cable is turned 2.5 rotations clockwise
Z3-9 (AU2) - J45-5 (AU2)
Spiral cable is turned 2.5 rotations
counterclockwise
Spiral cable is centered
Spiral cable is turned 2.5 rotations clockwise
CAUTION: The spiral cable is an important part of the SRS airbag system.
Incorrect removal or installation of the spiral cable may prevent
the airbag from deploying. Be sure to read the PRECAUTION for
the SRS (see PRECAUTION ).
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Audio/Visual - Tundra
Fig. 189: Identifying z3 And J45 Connectors Terminals
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
NG: REPLACE SPIRAL CABLE (See REMOVAL )
OK: REPAIR OR REPLACE HARNESS OR CONNECTOR (SPIRAL CABLE - RADIO
RECEIVER)
ILLUMINATION CIRCUIT
DESCRIPTION
Power is supplied to the radio receiver and steering pad switch illumination when the light control switch is in
the TAIL or HEAD position.
WIRING DIAGRAM
Fig. 190: Illumination - Wiring Diagram
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Audio/Visual - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст