Toyota Tundra. Manual — part 204
Fig. 183: Identifying K9 And K3 Connectors Terminals
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
4. Measure the voltage between terminal SPD of the wire harness connector and body ground
when the drive wheels are turned slowly.
OK: Voltage pulses as shown in the illustration.
Result:
RESULT REFERENCE
Result
Proceed to
NG
A
OK (for Column Shift Type)
B
OK (for Floor Shift Type)
C
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Audio/Visual - Tundra
B: REPLACE RADIO RECEIVER (see REMOVAL )
C: REPLACE RADIO RECEIVER (see REMOVAL )
Fig. 184: Voltage Pulses Pattern
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
A: Go to next step.
3. CHECK HARNESS AND CONNECTOR (COMBINATION METER - RADIO RECEIVER)
a. Disconnect the K3*1 or K9*2 receiver connector.
HINT:
*1: for Built-in Type Amplifier System
*2: for Separate Type Amplifier System
b. Disconnect the J28 meter connector.
c. Measure the resistance according to the value(s) in the table below.
Standard resistance:
for Separate Type Amplifier System
TESTER CONNECTION SPECIFIED CONDITION
for Built-in Type Amplifier System
TESTER CONNECTION SPECIFIED CONDITION
Tester Connection
Condition Specified Condition
K9-4 (SPD) - J28-35 (+S)
Always
Below 1 ohms
K9-4 (SPD) - Body ground
10 kohms or higher
Tester Connection
Condition Specified Condition
K3-3 (SPD) - J28-35 (+S)
Always
Below 1 ohms
K3-3 (SPD) - Body ground
10 kohms or higher
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Audio/Visual - Tundra
NG: REPAIR OR REPLACE HARNESS OR CONNECTOR
Fig. 185: Checking Harness And Connector (Combination Meter - Radio Receiver)
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
OK: REPLACE COMBINATION METER (See REMOVAL )
STEERING PAD SWITCH CIRCUIT
DESCRIPTION
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Audio/Visual - Tundra
This circuit sends an operation signal from the steering pad switch to the radio receiver. If there is an open in
the circuit, the audio system cannot be operated using the steering pad switch. If there is a short in the circuit,
the same condition as when the switch is continuously depressed occurs. Therefore, the radio receiver cannot be
operated using the steering pad switch, and also the radio receiver itself cannot function.
WIRING DIAGRAM
Fig. 186: Steering Pad Switch - Wiring Diagram
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
INSPECTION PROCEDURE
1. INSPECT RADIO RECEIVER
a. Disconnect the K3 receiver connector.
b. Measure the resistance according to the value(s) in the table below.
Standard resistance
CAUTION: The vehicle is equipped with an SRS (Supplemental Restraint System)
which includes components such as airbags. Before servicing (including
removal or installation of parts), be sure to read the precautionary notice
for the SRS (see PRECAUTION ).
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Audio/Visual - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст