Toyota Tundra. Manual — part 2350
Fig. 40: Identifying Engine Wire Protector Bolt
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
f
Install the starter with the 2 bolts
Torque: 25 N*m (255 kgf*cm, 18 ft.*lbf)
2009 Toyota Tundra
2009 ENG NE Starting (2UZ-FE) - Tundra
Fig. 41: Locating Starter Assembly Bolts
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
2
INSTALL AIR PUMP ASSEMBLY (See INSTALLATION )
3
INSTALL NO. 4 AIR INJECTION SYSTEM HOSE
4
INSTALL WATER BY-PASS PIPE SUB-ASSEMBLY (See INSTALLATION )
5
INSTALL INTAKE MANIFOLD ASSEMBLY
a
Install the intake manifold (see INSTALLATION )
6
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
STARTER (FOR 2.0 KW TYPE)
COMPONENTS
Fig. 42: Identifying Starter Replacement Components With Torque Specifications (1 Of 5)
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
Fig. 43: Identifying Starter Replacement Components With Torque Specifications (2 Of 5)
NOTE:
Some systems need to be initialized after the cable is reconnected (see
INITIALIZATION ).
2009 Toyota Tundra
2009 ENG NE Starting (2UZ-FE) - Tundra
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
Fig. 44: Identifying Starter Replacement Components With Torque Specifications (3 Of 5)
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
Fig. 45: Identifying Starter Replacement Components With Torque Specifications (4 Of 5)
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
2009 Toyota Tundra
2009 ENG NE Starting (2UZ-FE) - Tundra
Fig. 46: Identifying Starter Replacement Components With Torque Specifications (5 Of 5)
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
REMOVAL
1
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2
REMOVE INTAKE MANIFOLD ASSEMBLY
a
Remove the intake manifold (See REMOVAL )
3
REMOVE WATER BY-PASS PIPE SUB-ASSEMBLY (See REMOVAL )
4
REMOVE NO. 4 AIR INJECTION SYSTEM HOSE
5
REMOVE AIR PUMP ASSEMBLY (See REMOVAL )
6
REMOVE STARTER ASSEMBLY
a
Remove the 2 bolts holding the starter to the cylinder block
Fig. 47: Locating Starter Assembly Bolts
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b
Disconnect the starter from the cylinder block
c
Remove the bolt and disconnect the engine wire protector from the starter
NOTE:
Some systems need to be initialized after the cable is reconnected
(see INITIALIZATION ).
After the ignition switch is turned OFF, the navigation system
requires approximately 90 seconds to record various types of
memory and settings. As a result, after turning the ignition switch
OFF, wait 90 seconds or more before disconnecting the cable from
the negative (-) battery terminal.
2009 Toyota Tundra
2009 ENG NE Starting (2UZ-FE) - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст