Toyota Tundra. Manual — part 1769
b
Remove the bolt and purge VSV
Fig. 101: Identifying Purge VSV Bolts
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
INSPECTION
1
INSPECT PURGE VSV
a
Measure the resistance according to the value(s) in the table below
Standard resistance
PURGE VSV STANDARD RESISTANCE SPECIFICATION
Tester Connection
Condition Specified Condition
1 - 2
20°C (68°F)
23 to 26 ohms
1 - VSV body ground
Always
10 kohms or higher
2 - VSV body ground
10 kohms or higher
2009 Toyota Tundra
2009 ENG NE Emission Control (3UR-FE) - Tundra
Fig. 102: Inspecting Purge VSV
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
If the result is not as specified, replace the purge VSV
b
Inspect the purge VSV operation
1
Check that air does not flow from ports
Fig. 103: Inspecting Purge VSV Operation
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
2
Apply battery voltage across the terminals
2009 Toyota Tundra
2009 ENG NE Emission Control (3UR-FE) - Tundra
Fig. 104: Applying Battery Voltage Across Terminals
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
3
Check that air flows from ports
If operation is not as specified, replace the purge VSV
INSTALLATION
1
INSTALL PURGE VSV
a
Install the purge VSV with the bolt
Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf)
Fig. 105: Identifying Purge VSV With Bolt
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b
Connect the connector
2
CONNECT PURGE LINE HOSE
a
Connect the 2 hoses
2009 Toyota Tundra
2009 ENG NE Emission Control (3UR-FE) - Tundra
HINT:
Turn the clip claw to the upper side
3
INSTALL V-BANK COVER (See INSTALLATION )
FUEL TANK CAP
INSPECTION
1
INSPECT FUEL TANK CAP ASSEMBLY
a
Visually check if the cap and/or gasket are deformed or damaged
If the result is not as specified, replace the fuel tank cap assembly or gasket
Fig. 106: Inspecting Fuel Tank Cap Assembly
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
PCV VALVE
COMPONENTS
2009 Toyota Tundra
2009 ENG NE Emission Control (3UR-FE) - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст