Toyota Tundra. Manual — part 699

Disarmed state

by wireless operation.



With all doors and engine hood closed, lock all doors
using mechanical key.



With any door or the engine hood open, lock all doors
and close all doors and engine hood.

Arming preparation
state

Arming
preparation state

Perform any of following, and system will go on to
"Disarmed state":



Unlock all doors by wireless operation.



Unlock all doors using mechanical key.



Unlock a door.



Open engine hood.



Insert key into ignition key cylinder and turn ignition
switch ON or ACC.



Reconnect battery.

Disarmed state

Perform following, and system will go on to "Armed state":



Allow 30 (+/-1.5) seconds to elapse.

Armed state

Armed State

Perform any of following, and system will go on to
"Disarmed state":



Unlock all doors by wireless operation.



Unlock all doors using mechanical key.



Insert key into ignition key cylinder and turn ignition
switch ON.

Disarmed state

Perform any of following, and system will go on to "Alarm
sounding state":



Open engine hood.



Open a door.



Unlock a door without using wireless operation.



Unlock a door without using mechanical key.



Disconnect and reconnect battery negative (-) cable.



Force engine ignition system to turn on without proper
engine start method.

Alarm sounding state

Alarm sounding
state

Perform any of following, and system will go on to
"Disarmed state":



Unlock all doors by wireless operation.



Unlock all doors using mechanical key.



Insert key into ignition key cylinder and turn ignition
switch ON.

Disarmed state

2009 Toyota Tundra

2009 ACCESSORIES AND EQUIPMENT Theft Deterrent - Tundra

2. PASSIVE ARMING MODE

HINT:



Disarmed state (1) is the normal disarmed state.



Disarmed state (2) is set from either disarmed state (1) or the arming preparation state.



Passive arming mode can be turned on and off using the Techstream.



The vehicle's initial alarm setting is active arming mode.



During passive arming mode, the theft deterrent system enters the armed state even if the doors are
not locked.



Passive arming mode starts the alarm control after the doors are closed.



Detecting that the doors are unlocked does not set off the alarm during passive arming mode.



A forced door lock signal is not output during passive arming mode (refer to 3 for "FORCED
DOOR LOCK CONTROL").



When the theft deterrent system detects that the doors are opened during passive arming mode, the
alarm may not set off immediately depending on the entry delay time setting.



If any of the following conditions is fulfilled during passive arming mode, the theft deterrent
system will be changed to active arming mode.



With all doors and engine hood closed, lock all doors by wireless operation.



With any doors or engine hood open, lock all doors and close all doors and engine hood.

STATE SWITCHING CONDITION CHART

Perform following, and system will go on to "Armed state":



Allow 60 (+/-5) seconds to elapse.

Armed state (alarm
stops sounding)

System state

State switching condition

Switches to

Disarmed state (1)

Perform following, and system will go on to "Disarmed
state (2)":



With ignition switch OFF, open a door or engine
hood.

Disarmed state (2)

Disarmed state (2)

Perform following, and system will go on to "Arming
preparation state":



Close all doors and engine hood.

Arming preparation
state

Perform any of following, and system will go on to
"Disarmed state (1)":



Press UNLOCK button on wireless transmitter.



Insert mechanical key into driver side door key
cylinder and turn key to unlock direction.



Insert key into ignition key cylinder and turn ignition

Disarmed state (1)

2009 Toyota Tundra

2009 ACCESSORIES AND EQUIPMENT Theft Deterrent - Tundra

switch ON.



Disconnect and reconnect cable from battery negative
(-) terminal.

Arming preparation
state

Perform following, and system will go on to "Armed state":



Allow 30 (+/-1.5) seconds to elapse.

Armed state

Perform following, and system will go on to "Disarmed
state (2)":
Open a door or engine hood.

Disarmed state (2)

Perform any of following, and system will go on to
"Disarmed state (1)":



Press UNLOCK button on wireless transmitter.



Insert mechanical key into driver side door key
cylinder and turn key to unlock direction.



Insert key into ignition key cylinder and turn ignition
switch ON.



Disconnect and reconnect cable from battery negative
(-) terminal.

Disarmed state (1)

Armed state

Perform any of following, and system will go on to
"Disarmed state (1)":



Press UNLOCK button on wireless transmitter.



Insert mechanical key into driver side door key
cylinder and turn key to unlock direction.



Insert key into ignition key cylinder and turn ignition
switch ON.

Disarmed state (1)

Perform any of following, and system will go on to "Alarm
sounding state":



Open a door and allow entry delay time* to elapse.



Open engine hood.



Disconnect and reconnect cable from battery negative
(-) terminal.



Force engine ignition system to turn on without using
proper engine start method.

Alarm sounding state

Alarm sounding state

Perform any of following, and system will go on to
"Disarmed state (1)":



Press UNLOCK button on wireless transmitter.



Insert mechanical key into driver side door key
cylinder and turn key to unlock direction.



Insert key into ignition key cylinder and turn ignition
switch ON.

Disarmed state (1)

2009 Toyota Tundra

2009 ACCESSORIES AND EQUIPMENT Theft Deterrent - Tundra

The entry delay time can be selected among the following: 0, 14 or 30 seconds.

3. FORCED DOOR LOCK CONTROL

a. The forced door lock control also helps to prevent the vehicle from being tampered with. When a

door is unlocked and the alarm starts, the door is forced to lock by a forced door lock signal.

1. Conditions that force the doors to lock:



0.4 seconds have elapsed after the previous output of a forced door lock signal.



The theft deterrent system is in the alarm sounding state of active arming mode.



A door is unlocked.

4. PANIC ALARM CONTROL

a. The panic alarm control activates the panic alarm when the wireless transmitter PANIC switch is

pressed. The panic alarm control operates independently from the theft deterrent system alarm
control's change from the armed state to the alarm sounding state.

1. Conditions that cause the panic alarm control to set off the panic alarm:

The panic alarm is activated when the PANIC switch on the wireless transmitter is pressed
and held for 2.4 seconds or more under the following conditions.



The ignition switch is OFF.



The theft deterrent system is not in the alarm sounding state.



The panic alarm control is not operating (the alarm is not set off).

2. Conditions that cause the panic alarm control to shut off the alarm:

The panic alarm is deactivated when any of the following conditions is fulfilled during panic
alarm operation.



The ignition switch is turned ON.



The wireless transmitter lock/unlock switch is pressed.



60 +/-5 seconds have passed and the panic alarm has ended.



The theft deterrent system changes to the alarm sounding state. However, the alarm
still sounds, because the theft deterrent system has changed to the alarm sounding
state.

Perform following, and system will go on to "Armed state":



Allow 60 (+/-5) seconds to elapse.

Armed state (alarm
stops)

HINT:
*: When a door is opened while all other doors are closed during passive arming mode, the entry delay
time starts. If the state switching condition [from armed state to disarmed state (1) or (2)] is fulfilled
during the entry delay time, the theft deterrent system will return to disarmed state (1) or (2). However, if
the state switching condition is not fulfilled, the theft deterrent system will assume that a break-in or
theft is occurring and sounds the alarm.

2009 Toyota Tundra

2009 ACCESSORIES AND EQUIPMENT Theft Deterrent - Tundra