Toyota Tundra. Manual — part 1729
5
REMOVE NO. 2 AIR TUBE
a
Disconnect the air pump connector
Fig. 62: Identifying Air Pump Connector
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b
Disconnect the wire harness clamp
c
Remove the 4 nuts, No 2 air tube and 2 gaskets
Fig. 63: Identifying No. 2 Air Tube And Gaskets
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
6
REMOVE AIR SWITCHING VALVE ASSEMBLY
a
Remove the 3 nuts and air switching valve
NOTE:
Be careful not to damage the installation surface of the gaskets.
NOTE:
Do not hold the bracket of the air switching valve.
2009 Toyota Tundra
2009 ENG NE Emission Control (2UZ-FE) - Tundra
Fig. 64: Identifying Air Switching Valve
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
INSPECTION
1
INSPECT AIR SWITCHING VALVE ASSEMBLY
a
Measure the resistance according to the value(s) in the table below
Standard resistance
AIR SWITCHING VALVE ASSEMBLY STANDARD RESISTANCE SPECIFICATION
Tester Connection Condition Specified Condition
1 - 5
20°C (68°F)
4 5 to 5 5 ohms
1 - Body ground
Always
1 Mohms or higher
5 - Body ground
2009 Toyota Tundra
2009 ENG NE Emission Control (2UZ-FE) - Tundra
Fig. 65: Inspecting Air Switching Valve Assembly
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
If the result is not as specified, replace the air switching valve assembly
b
Check operation of the air switching valve
Fig. 66: Checking Operation Of Air Switching Valve
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
1
Check that air does not flow from port A to port B
If the result is not as specified, replace the air switching valve
2
Apply battery voltage across terminals 1 and 5
NOTE:
When measuring the resistance, do not touch terminals 2, 3, and 4.
NOTE:
Make sure the applied pressure is 30 kPa (0.3 kgf/cm
2
, 4.4 psi)
or less.
NOTE:
When applying voltage, do not touch terminals 2, 3, and 4.
2009 Toyota Tundra
2009 ENG NE Emission Control (2UZ-FE) - Tundra
Fig. 67: Applying Battery Voltage Across Terminals 1 And 5
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
3
Check that air flows from port A to port B
If the result is not as specified, replace the air switching valve
INSTALLATION
1
INSTALL AIR SWITCHING VALVE ASSEMBLY
a
Install the air switching valve with the 3 nuts
Torque: 16 N*m (163 kgf*cm, 12 ft.*lbf)
NOTE:
Do not hold the bracket of the air switching valve.
2009 Toyota Tundra
2009 ENG NE Emission Control (2UZ-FE) - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст