Toyota Tundra. Manual — part 1728
2
INSTALL NO. 3 AIR TUBE
a
Temporarily install a new gasket and the No 3 air tube to the exhaust manifold side with the 2 nuts
Fig. 55: Identifying No. 3 Air Tube With Nuts
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b
Install a new gasket and the No 3 air tube to the air switching valve side with the 2 nuts
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
c
Tighten the 2 nuts on the exhaust manifold side
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
3
INSTALL NO. 2 AIR HOSE
a
Install the No 2 air hose
Fig. 56: Identifying Air Hose Clamp
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b
Connect the air pump connector
NOTE:
Do not hold the bracket of the air switching valve.
2009 Toyota Tundra
2009 ENG NE Emission Control (2UZ-FE) - Tundra
Fig. 57: Identifying Air Pump Connector
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
c
Connect the fuel hose clamp
4
INSTALL FRONT FENDER APRON SEAL LH
a
Install the fender apron seal with the 5 clips
Fig. 58: Identifying Fender Apron Seal LH With Clips
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
5
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
AIR SWITCHING VALVE (FOR BANK 2)
COMPONENTS
NOTE:
Some systems need to be initialized after the cable is reconnected (see
INITIALIZATION ).
2009 Toyota Tundra
2009 ENG NE Emission Control (2UZ-FE) - Tundra
Fig. 59: Identifying Air Switching Valve Components (Bank 2) With Torque Specifications
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
REMOVAL
1
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE:
Some systems need to be initialized after the cable is reconnected
(see INITIALIZATION ).
After the ignition switch is turned OFF, the navigation system
requires approximately 90 seconds to record various types of
memory and settings. As a result, after turning the ignition switch
2009 Toyota Tundra
2009 ENG NE Emission Control (2UZ-FE) - Tundra
2
REMOVE FRONT FENDER APRON SEAL RH
a
Remove the 5 clips and fender apron seal
Fig. 60: Identifying Fender Apron Seal RH With Clips
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
3
DISCONNECT NO. 1 WATER BYPASS PIPE
Fig. 61: Identifying No. 1 Water By-Pass Pipe And Bolts
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
a
Remove the 2 bolts and disconnect the water bypass pipe
4
DISCONNECT NO. 2 AIR INJECTION SYSTEM HOSE
a
Disconnect the air injection system hose from the air switching valve
OFF, wait 90 seconds or more before disconnecting the cable from
the negative (-) battery terminal.
NOTE:
Do not disconnect the hoses. If it is necessary to disconnect the
hoses, first drain the engine coolant.
2009 Toyota Tundra
2009 ENG NE Emission Control (2UZ-FE) - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст