Toyota Tundra. Manual — part 902
Fig. 18: Sliding Roof ECU Power Source - Wiring Diagram
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
INSPECTION PROCEDURE
1. READ VALUE USING TECHSTREAM (IGNITION SWITCH SIGNAL)
a. Use the Data List to check if the ignition switch signal is functioning properly (see DATA LIST /
ACTIVE TEST ).
Sliding Roof
TECHSTREAM SLIDING ROOF - DATA LIST
OK: The Techstream displays as shown in the table according to the operation of each switch.
NG: Go to step 2
OK: REPLACE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (SLIDING ROOF ECU) (see
DISASSEMBLY )
2. INSPECT FUSE (S/ROOF, ECU-IG No. 1)
a. Remove the S/ROOF and ECU-IG No. 1 fuses from the main body ECU.
b. Measure the resistance according to the value(s) in the table below.
Tester Display
Test Part
Control Range
Diagnostic
Note
Ignition (MPX)
Ignition switch signal (MPX
signal)/ON or OFF
ON: Ignition switch
ON
OFF: Ignition switch
OFF
-
Ignition (Direct
Signal)
Ignition switch signal/ON or OFF
ON: Ignition switch
ON
OFF: Ignition switch
OFF
-
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Sliding Roof - Tundra
Standard resistance
INSPECT FUSE (S/ROOF, ECU-IG No. 1) RESISTANCE SPECIFICATION
NG: REPLACE FUSE
OK: Go to Next Step
3. CHECK HARNESS AND CONNECTOR (SLIDING ROOF ECU - BATTERY AND BODY
GROUND)
a. Disconnect the W3 ECU connector.
b. Measure the voltage according to the value(s) in the table below.
Standard voltage
HARNESS AND CONNECTOR (SLIDING ROOF ECU - BATTERY AND BODY
GROUND) VOLTAGE SPECIFICATION
c. Measure the resistance according to the value(s) in the table below.
Standard resistance
HARNESS AND CONNECTOR (SLIDING ROOF ECU - BATTERY AND BODY
GROUND) RESISTANCE SPECIFICATION
Tester Connection Condition Specified Condition
S/ROOF fuse
Always
Below 1 ohms
ECU-IG No. 1 fuse Always
Below 1 ohms
Tester Connection
Switch Condition Specified Condition
W3-9 (IG) - Body ground Ignition switch ON
11 to 14 V
W3-9 (IG) - Body ground Ignition switch OFF
Below 1 V
W3-10(B) - Body ground
Always
11 to 14 V
Tester Connection
Condition Specified Condition
W3-8 (E) - Body ground Always
Below 1 ohms
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Sliding Roof - Tundra
Fig. 19: Identifying W3 ECU Connector Terminals
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
NG: REPAIR OR REPLACE HARNESS OR CONNECTOR
OK: REPLACE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (SLIDING ROOF ECU) (see
DISASSEMBLY )
SLIDING ROOF HOUSING (FOR CREWMAX)
COMPONENTS
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Sliding Roof - Tundra
Fig. 20: Identifying Sliding Roof Housing Replacement Components With Torque Specifications (For
CrewMax) (1 Of 2)
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Sliding Roof - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст