Toyota Tundra. Manual — part 152
Fig. 41: Short In Speaker - Wiring Diagram (1 Of 2)
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Audio/Visual - Tundra
Fig. 42: Short In Speaker - Wiring Diagram (2 Of 2)
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
INSPECTION PROCEDURE
HINT:
After the inspection is completed, clear the DTCs.
1. CHECK DTC
a. Disconnect the K16 and K17 amplifier connectors.
b. Clear the DTC.
c. Check if DTC 74-40 is output.
OK: DTC 74-40 is not output.
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Audio/Visual - Tundra
NG: REPLACE STEREO COMPONENT AMPLIFIER (see REMOVAL )
OK: Go to Next Step
2. CHECK DTC
a. Reconnect the K16 amplifier connector.
b. Check if DTC 74-40 is output.
OK: DTC 74-40 is not output.
NG: Go to step 7
OK: Go to Next Step
3. CHECK HARNESS AND CONNECTOR (STEREO COMPONENT AMPLIFIER - SPEAKER)
a. Disconnect the K17 amplifier connector.
b. Measure the resistance according to the value(s) in the table below.
Standard resistance
TESTER CONNECTION SPECIFIED CONDITION
Fig. 43: Identifying K17 Amplifier Connector Terminals
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
NG: REPAIR OR REPLACE HARNESS OR CONNECTOR
Tester Connection
Condition Specified Condition
K17-2 (WFL+) - Body ground
Always
10 kohms or higher
K17-1 (WFL-) - Body ground
K17-9 (WFR+) - Body ground
K17-3 (WFR-) - Body ground
K17-4 (CTR+) - Body ground
K17-10 (CTR-) - Body ground
K17-5 (WF1+) - Body ground
K17-12 (WF1-) - Body ground
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Audio/Visual - Tundra
OK: Go to Next Step
4. INSPECT FRONT NO. 1 SPEAKER LH
a. Disconnect the N10 speaker connector.
b. Measure the resistance according to the value(s) in the table below.
Standard resistance
TESTER CONNECTION SPECIFIED CONDITION
NG: REPLACE FRONT NO. 1 SPEAKER LH (see REMOVAL )
Fig. 44: Identifying N10 Speaker Connector Terminals
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
OK: Go to Next Step
5. INSPECT FRONT NO. 1 SPEAKER RH
a. Disconnect the M8 speaker connector.
b. Measure the resistance according to the value(s) in the table below.
Standard resistance
TESTER CONNECTION SPECIFIED CONDITION
NG: REPLACE FRONT NO. 1 SPEAKER RH (see REMOVAL )
Tester Connection Condition Specified Condition
1 - 2
Always
1.5 to 2.1 ohms
Tester Connection Condition Specified Condition
1 - 2
Always
1.5 to 2.1 ohms
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Audio/Visual - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст