Toyota Tundra. Manual — part 2873
12. REMOVE NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY
a. Remove the 4 bolts of the rear engine mounting insulator.
Fig. 301: Locating Rear Engine Mounting Insulator Bolts
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b. Remove the 4 nuts, 4 washers, 4 bolts and frame crossmember.
Fig. 302: Locating Frame Crossmember Nuts, Washers & Bolts
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
13. REMOVE REAR NO. 1 ENGINE MOUNTING INSULATOR
a. Remove the 4 bolts and rear engine mounting insulator from the transmission.
Fig. 303: Locating Rear Engine Mounting Insulator Bolts
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
2009 Toyota Tundra
2009 TRANSMISSION AB60F Automatic Transaxle - Tundra
14. DISCONNECT WIRE HARNESS AND CONNECTOR
a. Remove the bolt and disconnect the ground cable.
Fig. 304: Locating Ground Cable Bolt
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b. Tilt the transmission downward.
Fig. 305: Tilting Transmission Downward
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
c. Disconnect the park/neutral position switch connector, 2 transmission wire connectors, 2 speed
sensor connectors and 3 transfer control side connectors.
HINT:
Detach the claw, press down the lever, and then disconnect the transmission wire connector.
d. Disconnect the 3 connector clamps and 7 harness clamps.
e. Remove the 2 bolts and disconnect the harness clamps and wire harness.
NOTE:
Make sure the cooling fan does not contact the fan shroud.
2009 Toyota Tundra
2009 TRANSMISSION AB60F Automatic Transaxle - Tundra
Fig. 306: Locating Connector Clamps & Harness Clamps
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
15. DISCONNECT BREATHER PLUG HOSE
a. Disconnect the 3 breather plug hoses from the harness clamp bracket.
Fig. 307: Locating Breather Plug Hoses
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
16. DISCONNECT NO. 2 WATER BY-PASS PIPE (w/ Trailer Towing System)
a. Remove the bolt and disconnect the 2 water bypass hoses from the transmission oil cooler. Then
separate the by-pass pipe from the automatic transmission.
2009 Toyota Tundra
2009 TRANSMISSION AB60F Automatic Transaxle - Tundra
Fig. 308: Locating Water Bypass Hoses Bolts
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b. Disconnect the 2 transmission oil cooler hoses from the transmission oil thermostat.
Fig. 309: Locating Transmission Oil Cooler Hoses
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
17. DISCONNECT NO. 2 WATER BY-PASS PIPE (w/o Trailer Towing System)
a. Remove the bolt and disconnect the 2 water bypass hoses from the transmission oil cooler. Then
separate the by-pass pipe from the automatic transmission.
NOTE:
Use a container to catch any coolant which flows out of the water by-
pass hoses.
NOTE:
Use a container to catch any coolant which flows out of the water by-
pass hoses.
2009 Toyota Tundra
2009 TRANSMISSION AB60F Automatic Transaxle - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст