Toyota Tundra. Manual — part 1453
OK : Go to Next Step
9. INSPECT FUEL PUMP
a. Inspect the fuel pump. (See INSPECTION ).
NG : REPLACE FUEL PUMP . (See FUEL PUMP ).
OK : Go to Next Step
10. CHECK HARNESS AND CONNECTOR (FUEL PUMP ECU - ECM AND BODY GROUND)
a. Disconnect the R7 fuel pump ECU connector.
b. Disconnect the A24 ECM connector.
c. Measure the resistance according to the value(s) in the table below.
Standard resistance
STANDARD RESISTANCE SPECIFICATION
Tester Connection
Condition Specified Condition
R7-1 (FPC) - A24-52 (FPC)
Always
Below 1 ohms
R7-2 (DI) - A24-18 (DI)
Always
Below 1 ohms
R7-3 (E) - Body ground
Always
Below 1 ohms
R7-1 (FPC) or A24-52 (FPC) - Body ground Always
10 kohms or higher
R7-2 (DI) or A24-18 (DI) - Body ground
Always
10 kohms or higher
2008 Toyota Tundra
2008 ENGINE PERFORMANCE Engine Control System (2UZ-FE) - Tundra
Fig. 294: Identifying A24 ECM & R7 Fuel Pump ECU Connectors
NG : REPAIR OR REPLACE HARNESS OR CONNECTOR
OK : Go to Next Step
11. REPLACE FUEL PUMP ECU
a. Replace the fuel pump ECU. (See FUEL PUMP ECU ).
12. CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
a. Check the fuel pump operation.
OK: Malfunction has been repaired successfully.
NG : REPLACE ECM (See REMOVAL )
OK : END
13. CHECK HARNESS AND CONNECTOR (CIRCUIT OPENING RELAY (C/OPN) - IGN FUSE
AND INTEGRATION RELAY)
a. Remove the circuit opening relay (C/OPN) from the engine room relay block.
2008 Toyota Tundra
2008 ENGINE PERFORMANCE Engine Control System (2UZ-FE) - Tundra
b. Remove the IGN fuse from the engine room relay block.
c. Remove the integration relay from the engine room relay block.
d. Disconnect the 1B integration relay connector.
e. Measure the resistance according to the value(s) in the table below.
Standard resistance
STANDARD RESISTANCE SPECIFICATION
Tester Connection
Condition Specified Condition
C/OPN relay (2) - IGN fuse (2)
Always
Below 1 ohms
C/OPN relay (5) - 1B-4
Always
Below 1 ohms
C/OPN relay (2) or IGN fuse (2) - Body ground Always
10 kohms or higher
C/OPN relay (5) or 1B-4 - Body ground
Always
10 kohms or higher
2008 Toyota Tundra
2008 ENGINE PERFORMANCE Engine Control System (2UZ-FE) - Tundra
Fig. 295: Identifying 1B Integration Relay Connector & Relay (C/OPN)
NG : REPAIR OR REPLACE HARNESS OR CONNECTOR
OK : GO TO ECM POWER SOURCE CIRCUIT
FUEL INJECTOR CIRCUIT
DESCRIPTION
The fuel injectors are located on the intake manifold. They inject fuel into the cylinders based on the signals
from the ECM.
WIRING DIAGRAM
Fig. 296: Fuel Injector - Wiring Diagram
INSPECTION PROCEDURE
2008 Toyota Tundra
2008 ENGINE PERFORMANCE Engine Control System (2UZ-FE) - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст