Toyota Tundra. Manual — part 2223

Fig. 179: Identifying Engine Assembly With Torque Specifications (11 Of 13)
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

Fig. 180: Identifying Engine Assembly With Torque Specifications (12 Of 13)
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

2009 Toyota Tundra

2009 ENGINE Engine Mechanical (3UR-FBE) - Tundra

Fig. 181: Identifying Engine Assembly With Torque Specifications (13 Of 13)
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

REMOVAL

1. DISCHARGE FUEL SYSTEM PRESSURE (See REMOVAL )

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

3. REMOVE NO. 1 ENGINE UNDER COVER (See REPLACEMENT )

4. DRAIN ENGINE OIL (See REPLACEMENT )

5. DRAIN ENGINE COOLANT (See COOLANT )

6. REMOVE HOOD SUB-ASSEMBLY

a. Using a screwdriver, release the 2 clips and remove the hood support assembly.

HINT:

Tape the screwdriver tip before use.

NOTE:



After the ignition switch is turned off, the navigation system requires
approximately 90 seconds to record various types of memory and
setting. As a result, after turning the ignition switch off, wait 90
seconds or more before disconnecting the cable from the negative (-)
battery terminal.



When disconnecting the cable some systems need to be initialized
after the cable is reconnected (See INITIALIZATION ).

CAUTION: Remove the hood support assembly while supporting the hood

by hand.

2009 Toyota Tundra

2009 ENGINE Engine Mechanical (3UR-FBE) - Tundra

Fig. 182: Removing Hood Support Assembly
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

b. Remove the 4 bolts and hood.

7. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY

a. Remove the windshield wiper motor (See REMOVAL ).

8. REMOVE COWL TOP OUTER PANEL SUB-ASSEMBLY (See REMOVAL )

9. REMOVE V-BANK COVER SUB-ASSEMBLY

a. Raise the front of the V-bank cover to detach the 2 pins. Then remove the 2 V-bank cover hooks

from the bracket, and remove the V-bank cover.

Fig. 183: Identifying V-Bank Cover Pins
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

10. REMOVE AIR CLEANER HOSE ASSEMBLY

a. Disconnect the vacuum hose and ventilation hose.

2009 Toyota Tundra

2009 ENGINE Engine Mechanical (3UR-FBE) - Tundra

Fig. 184: Locating Vacuum Hose, Ventilation Hose And Clips
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

b. Loosen the 2 clamps.

c. Remove the air cleaner hose.

11. REMOVE AIR CLEANER ASSEMBLY

a. Remove the air cleaner cap.

1. Disconnect the MAF meter connector.

2. Using a clip remover, detach the wire harness clamp.

3. Unfasten the 4 hook clamps and then remove the air cleaner cap.

2009 Toyota Tundra

2009 ENGINE Engine Mechanical (3UR-FBE) - Tundra