Toyota Tundra. Manual — part 702
Techstream
Main body
TECHSTREAM MAIN BODY REFERENCE CHART
Immobilizer
TECHSTREAM IMMOBILIZER REFERENCE CHART
ENGINE HOOD COURTESY SWITCH CIRCUIT
DESCRIPTION
The engine hood courtesy switch is built into the hood lock. This switch turns on when the engine hood is
opened and turns off when the engine hood is closed.
WIRING DIAGRAM
Fig. 6: Engine Hood Courtesy Switch - Wiring Diagram
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
INSPECTION PROCEDURE
1. READ VALUE OF TECHSTREAM (ENGINE HOOD COURTESY SWITCH)
a. Using Techstream, read the Data List.
Tester Display
Test Part
Control Range Diagnostic Note
Security Horn
Security horn
ON or OFF
-
Security Indicator Security indicator
ON or OFF
-
Tester Display
Test Part
Control Range Diagnostic Note
Security Indicator Security indicator
ON or OFF
-
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Theft Deterrent - Tundra
Techstream
Main Body
TECHSTREAM MAIN BODY REFERENCE CHART
OK: ON (engine hood is open) appears on screen.
NG: Go to step 2
OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS
TABLE
2. INSPECT HOOD LOCK ASSEMBLY (ENGINE HOOD COURTESY SWITCH)
Fig. 7: Identifying Hood Lock Assembly Lock And Unlock Position
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
a. Remove the hood lock (see REMOVAL ).
b. Measure the resistance according to the value(s) in the table below.
Standard resistance
HOOD LOCK ASSEMBLY (ENGINE HOOD COURTESY SWITCH)
Tester Display
Measurement Item/Range
Normal Condition
Diagnostic
Note
Hood Courtesy
Switch
Engine hood courtesy switch /
ON or OFF
ON: Engine hood is
open
OFF: Engine hood is
closed
-
Tester Connection
Condition
Specified Condition
1-2
UNLOCK position
Below 1 ohms
LOCK position
10 kohms or higher
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Theft Deterrent - Tundra
NG: REPLACE HOOD LOCK ASSEMBLY (ENGINE HOOD COURTESY SWITCH) (See
REMOVAL )
OK: Go to Next Step
3. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - ENGINE HOOD COURTESY
SWITCH AND BODY GROUND)
a. Disconnect the J4 main body ECU connector.
b. Disconnect the A29 engine hood courtesy switch connector.
c. Measure the resistance according to the value(s) in the table below.
Standard resistance
MAIN BODY ECU - ENGINE HOOD COURTESY SWITCH AND BODY GROUND
Fig. 8: Checking Harness And Connector (Main Body ECU - Engine Hood Courtesy Switch
Tester Connection
Condition Specified Condition
J4-16 (HCTY) - A29 - 1
Always
Below 1 ohms
A29-2 - Body ground
J4-16 (HCTY) or A29 - 1 - Body ground Always
10 kohms or higher
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Theft Deterrent - Tundra
And Body Ground)
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
NG: REPAIR OR REPLACE HARNESS OR CONNECTOR
OK: REPLACE MAIN BODY ECU
HORN CIRCUIT
DESCRIPTION
When the theft deterrent system changes from the armed state to the alarm sounding state, the main body ECU
transmits a signal to cause the horns to sound at 0.4 second intervals.
WIRING DIAGRAM
Fig. 9: Horn - Wiring Diagram
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
INSPECTION PROCEDURE
1. CHECK HORN ASSEMBLY
a. Press the horn switch and check if the vehicle horns sound normally.
OK: Vehicle horns sound normally.
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Theft Deterrent - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст