Toyota Tundra. Manual — part 1014
Fig. 29: Identifying Front Differential Side Gear Shaft Oil Seal Components (For 4WD)
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
REPLACEMENT
HINT:
The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless
otherwise specified.
1. DRAIN DIFFERENTIAL OIL (see REPLACEMENT )
2. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH
a. Remove the front drive shaft (see REMOVAL ).
2009 Toyota Tundra
2009 DRIVELINE/AXLES Differential - Tundra
3. REMOVE DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL
a. Using SST, tap out the 2 oil seals.
SST 09308-10010
Fig. 30: Tapping Out Oil Seals Using SST
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
4. INSTALL DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL
a. Apply MP grease to 2 new oil seals.
b. Using SST and a hammer, tap in the 2 oil seals.
SST 09550-00032, 09950-70010 (09951 -07100)
Fig. 31: Tapping In Oil Seals
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
Standard oil seal depth
NOTE:
Make sure the LH and RH oil seals are installed in the proper
locations.
2009 Toyota Tundra
2009 DRIVELINE/AXLES Differential - Tundra
OIL SEAL DEPTH SPECIFICATIONS
5. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH
a. Install the front drive shaft (see INSTALLATION ).
6. ADD DIFFERENTIAL OIL (see REPLACEMENT )
DIFFERENTIAL CARRIER ASSEMBLY (FOR 1GR-FE, 2UZ-FE)
COMPONENTS
Side
Specified Condition
LH -0.45 to 0.45 mm (-0.0177 to 0.0177 In.)
RH
4.8 to 5.8 mm (0.189 to 0.228 in.)
2009 Toyota Tundra
2009 DRIVELINE/AXLES Differential - Tundra
Fig. 32: Identifying Differential Carrier Assembly Replacement Components With Torque Specifications
(For 1GR-FE, 2UZ-FE) (1 Of 3)
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
2009 Toyota Tundra
2009 DRIVELINE/AXLES Differential - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст