Toyota Tundra. Manual — part 2800
HINT:
*1: for 3UR-FE
*2: for 3UR-FBE
TYPICAL MALFUNCTION THRESHOLDS
One of the following conditions is met: Condition (A), (B), (C) or (D)
Condition (A)
When 2 or more of the following signals are input at the same time
TYPICAL MALFUNCTION THRESHOLDS
HINT:
*: for 3UR-FBE
Condition (B) (for 3UR-FE)
When 2 or more of the following signals are input at the same time
TYPICAL MALFUNCTION THRESHOLDS
Condition (C)
When the shift lever is in S, one of the following conditions is met
TYPICAL MALFUNCTION THRESHOLDS
Condition (D)
Battery voltage
10.5 V or higher
P switch
ON
N switch
ON
R switch
ON
D switch
ON
NSW switch
ON
R switch
ON
D switch
ON
NSW switch
ON
P switch
ON
N switch
ON
R switch
ON
2009 Toyota Tundra
2009 TRANSMISSION AB60F Automatic Transaxle - Tundra
All of the following conditions are met
TYPICAL MALFUNCTION THRESHOLDS
COMPONENT OPERATING RANGE
COMPONENT OPERATING RANGE
WIRING DIAGRAM
P switch
OFF
N switch
OFF
NSW switch
OFF
R switch
OFF
D switch
OFF
Park/neutral position switch
The park/neutral position switch sends only one signal to the ECM
2009 Toyota Tundra
2009 TRANSMISSION AB60F Automatic Transaxle - Tundra
Fig. 21: Identifying Transmission Range Sensor Wiring Diagram
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
INSPECTION PROCEDURE
1. DATA LIST
HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and
other items to be read without removing any parts. This non-intrusive inspection can be very useful
because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading
the Data List information early in troubleshooting is one way to save diagnostic time.
a. Warm up the engine.
b. Turn the ignition switch off.
c. Connect the Techstream to the DLC3.
d. Turn the ignition switch to ON.
e. Turn the Techstream on.
f. Enter the following menus: Powertrain/Engine and ECT/Data List.
g. According to the display on the Techstream, read the Data List.
Engine and ECT:
DATA LIST TABLE
NOTE:
In the table below, the values listed under "Normal Condition" are
reference values. Do not depend solely on these reference values when
deciding whether a part is faulty or not.
Tester
Display
Measurement
Item/Range
Normal Condition
Diagnostic Note
Neutral
Position SW
Signal
PNP switch status/
ON or OFF
Shift lever is:
On P or N: ON
Not on P or N:
OFF
When shift lever position displayed on
Techstream differs from actual position,
adjustment of PNP switch or shift cable
may be incorrect
Shift SW
Status (R
Range)
PNP switch status/
ON or OFF
Shift lever is:
On R: ON
Not on R: OFF
When shift lever position displayed on
Techstream differs from actual position,
adjustment of PNP switch or shift cable
may be incorrect
Shift SW
Status (P
Range)
PNP switch status/
ON or OFF
Shift lever is:
On P: ON
Not on P: OFF
When shift lever position displayed on
Techstream differs from actual position,
adjustment of PNP switch or shift cable
may be incorrect
2009 Toyota Tundra
2009 TRANSMISSION AB60F Automatic Transaxle - Tundra
1. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY
a. Disconnect the D35 park/neutral position switch connector.
b. Measure the resistance according to the value (s) in the table below.
Standard resistance
TESTER CONNECTION SPECIFIED CONDITION TABLE
Shift SW
Status (N
Range)
PNP switch status/
ON or OFF
Shift lever is:
On N: ON
Not on N: OFF
When shift lever position displayed on
Techstream differs from actual position,
adjustment of PNP switch or shift cable
may be incorrect
Shift SW
Status (D
Range)
PNP switch status/
ON or OFF
Shift lever is:
On D: ON
Not on D: OFF
When shift lever position displayed on
Techstream differs from actual position,
adjustment of PNP switch or shift cable
may be incorrect
Sports Shift
Up SW
Sport shift up switch
status/ ON or OFF
ON: Shift lever
held in "+" (up-
shift)
OFF: Shift
lever not in
"+" (up-shift)
-
Sports Shift
Down SW
Sport shift down
switch status/ ON or
OFF
ON: Shift lever
held in "-
" (down-shift)
OFF: Shift
lever not in "-
" (down-shift)
-
Sports Mode
Selection
SW
Sport mode select
switch status/ ON or
OFF
Shift lever position is:
ON: S, "+" or
"-"
OFF: Not on S,
"+" or "-"
-
Tester Connection
Condition
Specified Condition
2 (RB) - 6 (PL)
4 (B) - 5 (L)
Shift lever position on P
Below 1 ohms
2 (RB) -1 (RL)
Shift lever position on R
Below 1 ohms
2 (RB) - 9 (NL)
4 (B) - 5 (L)
Shift lever position on N
Below 1 ohms
2 (RB) - 7 (DL)
Shift lever position on D
Shift lever position on S, "+" or "-"
Below 1 ohms
2009 Toyota Tundra
2009 TRANSMISSION AB60F Automatic Transaxle - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст