Toyota Tundra. Manual — part 869
panel.
Fig. 22: Identifying Quarter Trim Panel Bolts And Clips
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
27. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH
HINT:
Use the same procedures described for the LH side.
28. REMOVE ROOF CONSOLE BOX ASSEMBLY
a. for Short Type:
Remove the roof console box (see REMOVAL ).
b. for Long Type:
Remove the roof console box (see REMOVAL ).
29. REMOVE ROOM LIGHT ASSEMBLY (w/ Short Type Roof Console Box)
a. Using a screwdriver, detach the 4 claws and remove the lens.
HINT:
Tape the screwdriver tip before use.
b. Detach the 4 clips.
c. Disconnect the connector and then remove the room light.
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Interior - Tundra
Fig. 23: Identifying Room Light Lens, Claws And Clips
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
30. REMOVE VISOR BRACKET COVER LH
a. Using a moulding remover, detach the 4 claws and remove the visor bracket cover.
Fig. 24: Identifying Visor Bracket Cover Claws
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
31. REMOVE VISOR BRACKET COVER RH
HINT:
Use the same procedures described for the LH side.
32. REMOVE VISOR ASSEMBLY LH
a. w/o Illumination:
Remove the visor.
1. Remove the 3 screws and visor.
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Interior - Tundra
Fig. 25: Identifying Visor Assembly Screws (W/O Illumination)
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b. w/ Illumination:
Remove the visor.
1. Remove the 4 screws.
2. Disconnect the connector and then remove the visor.
Fig. 26: Identifying Visor Assembly Screws (W/Illumination)
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
33. REMOVE VISOR ASSEMBLY RH
HINT:
Use the same procedures described for the LH side.
34. REMOVE VISOR HOLDER (w/o Illumination)
a. Remove the screw and visor holder.
HINT:
Use the same procedure to remove the visor holder on the other side.
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Interior - Tundra
Fig. 27: Identifying Screw And Visor Holder
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
35. REMOVE ASSIST GRIP SUB-ASSEMBLY
a. Using a screwdriver, detach the 4 claws and remove the 2 assist grip covers.
HINT:
Tape the screwdriver tip before use.
b. Detach the 2 clips and remove the assist grip.
Fig. 28: Identifying Clips And Remove Assist Grip
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
36. REMOVE ASSIST GRIP PLUG
a. Insert a screwdriver into the service notch and break off the cap.
b. Detach the clip and remove the assist grip plug.
2009 Toyota Tundra
2009 ACCESSORIES AND EQUIPMENT Interior - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст