Toyota Tundra. Manual — part 1964
Fig. 288: Locating Engine Rear Oil Seal Retainer Bolts
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b
Using a screwdriver, pry out the oil seal retainer
HINT:
Tape the screwdriver tip before use
Fig. 289: Prying Out Oil Seal Retainer
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
53
REMOVE OIL DRAIN PIPE SUB-ASSEMBLY
a
Remove the bolt and oil drain pipe
2009 Toyota Tundra
2009 ENGINE Engine Mechanical (3UR-FBE) - Tundra
Fig. 290: Locating Bolt And Oil Drain Pipe
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b
Remove the O-ring
54
REMOVE REAR CRANKSHAFT OIL SEAL
Fig. 291: Removing Rear Crankshaft Oil Seal
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
a
Place the oil seal retainer on wooden blocks
b
Using a screwdriver and hammer, tap out the oil seal
55
REMOVE RING PIN
56
REMOVE STUD BOLT
INSPECTION
1
INSPECT CYLINDER HEAD SET BOLT
a
Using a vernier caliper, measure the diameter of the elongated thread at the measuring point
NOTE:
It is not necessary to remove the ring pin unless it is being replaced.
NOTE:
If the stud bolt is deformed or its threads are damaged, replace it.
2009 Toyota Tundra
2009 ENGINE Engine Mechanical (3UR-FBE) - Tundra
Standard diameter:
10.85 to 11.00 mm (0.427 to 0.433 in.)
Minimum diameter:
10.6 mm (0.417 in.)
If the diameter is less than the minimum, replace the cylinder head bolt
HINT:
If a visual check reveals no excessively thin areas, check the center of the bolt (see illustration ) and
find the area that has the lowest diameter
Fig. 292: Measuring Diameter Of Elongated Thread
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
2
INSPECT NO. 1 VALVE ROCKER ARM SUB-ASSEMBLY
a
Turn the roller by hand to check that it turns smoothly
If the roller does not turn smoothly, replace the valve rocker arm
Fig. 293: Turning Roller By Hand
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
2009 Toyota Tundra
2009 ENGINE Engine Mechanical (3UR-FBE) - Tundra
3
INSPECT VALVE LASH ADJUSTER ASSEMBLY
a
Place the lash adjuster into a container full of new engine oil
b
Insert SST's tip into the lash adjuster's plunger and use the tip to press down on the check ball
inside the plunger
SST 09276-75010
c
Squeeze SST and the lash adjuster together to move the plunger up and down 5 to 6 times
d
Check the movement of the plunger and bleed air
NOTE:
Keep the adjuster free from dirt and foreign objects.
Use only clean engine oil.
Fig. 294: Inspecting Valve Lash Adjuster Assembly
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
2009 Toyota Tundra
2009 ENGINE Engine Mechanical (3UR-FBE) - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст