Toyota Tundra. Manual — part 1982
Fig. 417: Locating Nuts, Washers, Bolts And Crossmember
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
3
REMOVE REAR NO. 1 ENGINE MOUNTING INSULATOR
a
Remove the 4 bolts and mounting insulator from the transmission
Fig. 418: Locating Mounting Insulator And Bolts
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b
Remove the bolt and mounting heat insulator
INSTALLATION
1
INSTALL REAR NO. 1 ENGINE MOUNTING INSULATOR
a
Install the mounting insulator to the transmission with the 4 bolts
Torque: 59 N*m (602 kgf*cm, 44 ft.*lbf)
2009 Toyota Tundra
2009 ENGINE Engine Mechanical (3UR-FBE) - Tundra
Fig. 419: Locating Mounting Insulator And Bolts
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b
Install the mounting heat insulator with the bolt
Torque: 12 N*m (122 kgf*cm, 9 ft.*lbf)
2
INSTALL NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY
a
Install the crossmember with the 4 bolts, 4 washers and 4 nuts
Torque: 110 N*m (1122 kgf*cm, 81 ft.*lbf)
Fig. 420: Locating Crossmember With Bolts, Washers And Nuts
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b
Install the 4 rear engine mounting insulator bolts
Torque: 16 N*m (163 kgf*cm, 12 ft.*lbf)
2009 Toyota Tundra
2009 ENGINE Engine Mechanical (3UR-FBE) - Tundra
Fig. 421: Locating Rear Engine Mounting Insulator Bolts
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
2009 Toyota Tundra
2009 ENGINE Engine Mechanical (3UR-FBE) - Tundra
2009 ENGINE
Engine Mechanical (3UR-FE) - Tundra
ENGINE
ON-VEHICLE INSPECTION
1
INSPECT IGNITION TIMING
a
Warm up and stop the engine
1
Allow the engine to warm up to a normal operating temperature
b
When using the Techstream:
1
Connect the Techstream to the DLC3
2
Start the engine and idle it
3
Push the Techstream main switch ON
4
Enter the following menus: Powertrain/Engine and ECT/Data List/Primary/IGN Advance
HINT:
Refer to the Techstream operator's manual for further details
Standard ignition timing: 8 to 12° BTDC @ idle (transmission in neutral and A/C
switch OFF)
5
Disconnect the Techstream from the DLC3
c
When not using the Techstream:
1
Connect the tester probe of a timing light to the wire of the ignition coil connector for the No
1 cylinder
Fig. 1: Connecting Tester Probe Of Timing Light To Wire Of Ignition Coil Connector
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
NOTE:
Use a timing light that detects primary signals.
2009 Toyota Tundra
2009 ENGINE Engine Mechanical (3UR-FE) - Tundra
2009 Toyota Tundra
2009 ENGINE Engine Mechanical (3UR-FE) - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст