Toyota Tundra. Manual — part 1981
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
INSTALLATION
1
INSTALL FRONT ENGINE MOUNTING INSULATOR LH
a
Install the mounting insulator with the nut
Torque: 72 N*m (734 kgf*cm, 53 ft.*lbf)
Fig. 410: Locating Mounting Insulator With Nut
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
2
INSTALL WATER DRAIN COCK SUB-ASSEMBLY
a
Apply seal packing to 2 or 3 threads of the drain cock
Seal packing:
Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
Fig. 411: Applying Seal Packing To Drain Cock Threads
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b
Install the drain cock to the cylinder block LH side
Torque: 30 N*m (306 kgf*cm, 22 ft.*lbf)
2009 Toyota Tundra
2009 ENGINE Engine Mechanical (3UR-FBE) - Tundra
Fig. 412: Locating Drain Cock
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
c
Further tighten the drain cock within 360° so that the drain cock pipe is within the range shown in
the illustration
3
INSTALL FRONT ENGINE MOUNTING INSULATOR RH
a
Install the mounting insulator with the nut
Torque: 72 N*m (734 kgf*cm, 53 ft.*lbf)
Fig. 413: Locating Mounting Insulator With Nut
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
4
INSTALL ENGINE ASSEMBLY
NOTE:
Do not rotate the drain cock more than 1 revolution (360°) after
tightening the drain cock to the specified torque.
Do not loosen the drain cock to adjust it. If an adjustment is
necessary, remove the drain cock and reinstall it.
2009 Toyota Tundra
2009 ENGINE Engine Mechanical (3UR-FBE) - Tundra
a
Install the engine assembly to the vehicle (See INSTALLATION )
REAR ENGINE MOUNTING
COMPONENTS
Fig. 414: Identifying Rear Engine Mounting Components With Torque Specifications
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
REMOVAL
2009 Toyota Tundra
2009 ENGINE Engine Mechanical (3UR-FBE) - Tundra
1
SUPPORT AUTOMATIC TRANSMISSION ASSEMBLY
a
Support the transmission with a transmission jack Lift the transmission slightly from the
crossmember
Fig. 415: Supporting Transmission With Transmission Jack
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
2
REMOVE NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY
a
Remove the 4 rear engine mounting insulator bolts
Fig. 416: Locating Rear Engine Mounting Insulator Bolts
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b
Remove the 4 nuts, 4 washers, 4 bolts and crossmember
2009 Toyota Tundra
2009 ENGINE Engine Mechanical (3UR-FBE) - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст