Toyota Sequoia (2005). Manual — part 808
BR1NL–04
BR–54
–
BRAKE
ABS & VSC ACTUATOR
3221
INSTALLATION
Installation is in the reverse order of removal (See page
HINT:
After installation, fill the brake reservoir with brake fluid and bleed brake system (See page
Check for leaks.
NOTICE:
In case of replacing the skid control ECU, perform the zero point calibration of the steering angle,
master cylinder pressure, yawrate and deceleration sensors (See page
).
BR0A2–05
F08184
8.0 (82, 71 in.·lbf)
8.0 (82, 71 in.·lbf)
Front Speed Sensor
: Specified torque
N·m (kgf·cm, ft·lbf)
8.0 (82, 71 in.·lbf)
–
BRAKE
FRONT SPEED SENSOR
BR–55
3222
FRONT SPEED SENSOR
COMPONENTS
BR0A3–04
F08186
BR–56
–
BRAKE
FRONT SPEED SENSOR
3223
REMOVAL
1.
REMOVE FRONT WHEEL
Torque: 110 N·m (1,122 kgf·cm, 81 ft·lbf)
2.
DISCONNECT SPEED SENSOR CONNECTOR
3.
REMOVE SPEED SENSOR
(a)
Remove the clips and 3 clamp bolts holding the sensor
harness from the frame, upper arm and steering knuckle.
Torque: 8.0 N·m (82 kgf·cm, 71 in.·lbf)
(b)
Remove the bolt and speed sensor from the steering
knuckle.
Torque: 8.0 N·m (82 kgf·cm, 71 in.·lbf)
BR0A4–07
–
BRAKE
FRONT SPEED SENSOR
BR–57
3224
INSTALLATION
Installation is in the reverse order of removal (See page
HINT:
After installation, check speed sensor signal (See page
).
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст