Toyota Sequoia (2005). Manual — part 807
BR1NH–03
F16314
Connector
11 (112, 8)
Actuator Bracket
Actuator
Cushion
Actuator Assembly
11 (112, 8)
1.8 (18, 16 in.·lbf)
: Specified torque
N·m (kgf·cm, ft·lbf)
19.5 (195, 14)
15 (155, 11)
Non–reusable part
19.5 (195, 14)
15 (155, 11)
15 (155, 11)
9.5 (97, 84 in.·lbf)
9.5 (97, 84 in.·lbf)
Skid Control ECU
Cushion
To left rear brake
To right front brake
To right rear brake
To left front brake
From master cylinder
(front port)
From master cylinder
(rear port)
15 (155, 11)
1.8 (18, 16 in.·lbf)
BR–50
–
BRAKE
ABS & VSC ACTUATOR
3217
COMPONENTS
BR1NI–03
F16315
Release Bar
F16316
–
BRAKE
ABS & VSC ACTUATOR
BR–51
3218
REMOVAL
1.
DISCONNECT CONNECTOR
Pull the release bar and disconnect the connector.
2.
DISCONNECT BRAKE LINES
Using SST, disconnect the 6 brake lines from the actuator as-
sembly.
SST
09023–00101, 09023–38201
Torque:
10 mm nut: 15 N·m (155 kgf·cm, 11 ft·lbf)
12 mm nut: 19.5 N·m (195 kgf·cm, 14 ft·lbf)
HINT:
When disconnecting the brake lines, use tags or make a
memo to identify the place to reconnect (See page
At the time of installation, connect each brake line to the
correct position (See page
).
3.
REMOVE ACTUATOR ASSEMBLY
Remove the 3 nuts and actuator assembly with the actuator
bracket.
Torque: 11 N·m (112 kgf·cm, 8 ft·lbf)
BR1NJ–03
F13898
Sealing
Surface
BR–52
–
BRAKE
ABS & VSC ACTUATOR
3219
DISASSEMBLY
1.
REMOVE ACTUATOR BRACKET
(a)
Remove the 3 bolts and actuator bracket.
Torque: 9.5 N·m (97 kgf·cm, 84 in.·lbf)
(b)
Remove the 3 cushions from the actuator bracket.
2.
REMOVE SKID CONTROL ECU
Using a E5 torx
®
wrench, remove the 3 screws and skid control
ECU.
Torque: 1.8 N·m (18 kgf·cm, 16 in.·lbf)
NOTICE:
Protect the actuator in order to prevent sealing surface
from getting dirty and causing damage on the valve body.
If the dirt and the like is stuck to the sealing surface, use
plastic tools or soft objects to remove the dirt. Do not use
chemical solvents.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст