Toyota Sequoia (2005). Manual — part 887
BE0G4–01
–
BODY ELECTRICAL
GARAGE DOOR OPENER SYSTEM
BE–133
3537
REMOVAL
1.
REMOVE FRONT PERSONAL LIGHT LENS
2.
REMOVE FRONT PERSONAL LIGHT
(a)
Remove the 3 screws.
(b)
Disconnect the 2 connectors.
3.
REMOVE GARAGE DOOR OPENER SWITCH
I18597
BE26F–03
I18598
I18599
BE–134
–
BODY ELECTRICAL
GARAGE DOOR OPENER SYSTEM
3538
INSPECTION
1.
INSPECT GARAGE DOOR OPENER SWITCH
(a)
Press the switch and check that each garage door indica-
tor (green) comes on.
(b)
Even if only one switch does not come on, replace it.
2.
INSPECT GARAGE DOOR OPENER REGISTRATION
AND TRANSMITTING
HINT:
Use the home link tester made by KENT MORE for this test.
As it is necessary to record the code of the hand held transmit-
ter, customer’s code will be erased. When the inspection is
complete, please register the customer’s again.
(a)
Check that the inspection code of the hand held transmit-
ter can be recorded (See page
).
If the code can not be registered, replace the garage door open-
er.
(b)
Press the switch which an inspection code has been reg-
istered for and check that garage door indicator (green)
of the home link tester comes on.
If the garage door indicator (green) does not come on, replace
the garage door opener.
I21538
Wire Harness Side:
I21537
Wire Harness Side:
–
BODY ELECTRICAL
GARAGE DOOR OPENER SYSTEM
BE–135
3539
3.
w/ Sliding Roof:
INSPECT GARAGE DOOR OPENER SWITCH CIRCUIT
Disconnect the connector from the switch and inspect the con-
nector on the wire harness side, as shown.
Tester connection
Condition
Specified condition
1 – Ground
Always
Continuity
3 – Ground
Always
Battery positive voltage
If the circuit is not as specified, inspect the power source or wire
harness.
4.
w/o Sliding Roof:
INSPECT GARAGE DOOR OPENER SWITCH CIRCUIT
Disconnect the connector from the switch and inspect the con-
nector on the wire harness side, as shown.
Tester connection
Condition
Specified condition
9 – Ground
Always
Battery positive voltage
13 – Ground
Always
Continuity
If the circuit is not as specified, inspect the power source or wire
harness.
BE0G6–01
BE–136
–
BODY ELECTRICAL
GARAGE DOOR OPENER SYSTEM
3540
INSTALLATION
1.
INSTALL GARAGE DOOR OPENER
2.
INSTALL FRONT PERSONAL LIGHT
(a)
Connect the 2 connectors.
(b)
Install the 3 screws.
3.
INSTALL FRONT PERSONAL LIGHT LENS
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст