Toyota Sequoia (2005). Manual — part 886
BE0G2–08
I18598
–
BODY ELECTRICAL
GARAGE DOOR OPENER SYSTEM
BE–129
3533
GARAGE DOOR OPENER SYSTEM
REGISTRATION PROCEDURE
1.
NEW CODE REGISTRATION
NOTICE:
If pressing the switch of the original transmitter to
register the code, the system might operate.
When registering the transmitter codes such as for
garage or gate, check that there is nobody around
those places.
(a)
Press the switch of the item to be registered for 20 se-
conds.
HINT:
When transferring to registration mode, garage door indicator
(green) blinks in 1 Hz cycle.
(b)
Bring the original transmitter to within 1–inch area around
the garage door opener and press the switch (code trans-
mitting).
HINT:
When code registration is complete correctly, the garage door
indicator (green) blinks in 5.6 Hz cycle.
I03487
GARAGE DOOR
OPENER SWITCH
LEARN MODE
INDICATOR
OPERATION
ORIGINAL
TRANSMITTER
PRESSED
ENTER
EXIT
ON
OFF
20 sec.
INDICATOR flashes
at a rate of 1 Hz
INDICATOR
flashes at a
rate of 5.6 Hz
RELEASED
ON
OFF
BE–130
–
BODY ELECTRICAL
GARAGE DOOR OPENER SYSTEM
3534
New code registration timing chart
If a code can not be registered, observe the following condi-
tions.
HINT:
If the battery of original transmitter is consumed.
Press the switch of the transmitter repeatedly in registra-
tion mode, as some transmitters stop transmitting for 1 to
2 seconds.
This system is not applicable to the garage door opener
which had been made before 1982.
2.
CODE DELETION
(a)
Press the switches at both ends of the garage door open-
er simultaneously for 20 seconds.
HINT:
When transferring to deletion mode, garage door indicator
(green) blinks in 6 Hz cycle.
(b)
When releasing the switch within 10 seconds after trans-
ferring to deletion mode, all the registered codes will be
erased.
HINT:
Press the switch until 6 Hz cycle blinking stops, so that the de-
fault code for check is set.
I21535
INDICATOR
OPERATION
GARAGE DOOR
OPENER SWITCH
(Switch at either end)
ON
OFF
ERASE/DEFAULT
MODE
PRESSED
LOAD DEFAULT
INDICATOR flashes at a rate of 5.6 HZ
10 SEC.
20 SEC.
RELEASED
ON
OFF
Enter in erase mode to
erase all 3 channels
LOAD DEFAULT
NEW CODE REGISTRATION
–
BODY ELECTRICAL
GARAGE DOOR OPENER SYSTEM
BE–131
3535
Code deletion timing chart
BE0G3–10
I28422
Instrument Panel J/B
ECU–IG Fuse
GAUGE Fuse
Overhead Module
GAUGE Door Opener Switch
BE–132
–
BODY ELECTRICAL
GARAGE DOOR OPENER SYSTEM
3536
LOCATION
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст