Toyota Sequoia (2005). Manual — part 704
D13872
Hand–Held Tester
DLC3
CAN VIM
Rich
Lean
Time
14.6
3.3
Keep Engine Speed
(V)
B17513
Air–fuel
Ratio
–
SFI
AIR–FUEL RATIO (A/F) SENSOR
SF–71
2805
(b)
Connect a hand–held tester to the Controller Area Net-
work Vehicle Interface Module (CAN VIM). Then connect
the CAN VIM to the Date Link Connector 3 (DLC3).
(c)
Turn the ignition switch ON.
(d)
Select the following menu items : Data List / A/FS B1 S1
and O2S B1 S2.
(e)
Warm up the A/F sensor by running the engine at 2,500
rpm for approximately 2 minutes.
(f)
Keep the engine speed at 2,500 rpm and confirm that the
display of the ”A/FS B1 S1” is as shown in the illustration.
HINT:
The illustration may slightly differ from the display on the
hand–held tester.
The waveform of the A/F sensor is displayed only on the
hannd–heldtester.
(g)
Confirm that the display of the ”O2S B1 S2” changes be-
tween 0 and 1 V with the engine speed at 2,500 rpm.
OK:
The voltage output oscillates more than 8 times in 10
seconds.
CAUTION:
Perform the check immediately after warming up the
engine.
If the voltage variation could not be verified, warm up
the heated oxygen sensor again. If it could not be veri-
fied even after warming up the sensor again, check
the DTC No. (See page
SF0Y9–11
B17506
N·m (kgf·cm, ft·lbf)
: Specified torque
Heated Oxygen
Sensor Connector
Heated Oxygen Sensor
Engine Under Cover
Bank 2 Sensor 1
44 (450, 32)
Bank 1 Sensor 1
Heated Oxygen
Sensor Connector
Heated Oxygen Sensor
44 (450, 32)
SF–72
–
SFI
HEATED OXYGEN SENSOR
2806
HEATED OXYGEN SENSOR
COMPONENTS
SF0YA–14
B17507
+B
HT
–
SFI
HEATED OXYGEN SENSOR
SF–73
2807
INSPECTION
1.
INSPECT HEATER RESISTANCE OF HEATED OXY-
GEN SENSOR
(a)
Disconnect the oxygen sensor connector.
(b)
Using an ohmmeter, measure the resistance between ter-
minals +B and HT.
Resistance: 11 to 16
Ω
at 20
°
C (68
°
F)
If the resistance is not as specified, replace the sensor.
Torque: 44 N·m (450 kgf·cm, 32 ft·lbf)
(c)
Reconnect the oxygen sensor connector.
2.
INSPECT OPERATION OF HEATED OXYGEN SEN-
SOR (See page
SF1XX–02
B17459
Throttle Body Cover
PS Air Hose
Intake Air Connector
Suction Hose
MAF Meter Wire
PCV Hose
Vacuum Hose
SF–74
–
SFI
VVT SENSOR
2808
VVT SENSOR
COMPONENTS
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст