Toyota Sequoia (2005). Manual — part 928
BO4SL–01
BO–148
–
BODY
REAR NO.1 SEAT (Split Type LH)
3701
INSTALLATION
Installation is in the reverse order of removal (See page
BO4SM–01
H16770
Headrest
Headrest
Support
Seatback Cover
Seatback Pad
Seatback Frame
Seat Cushion
Cover
Seat Cushion Pad
Seat Cushion
Frame
Fold Seat
Stopper Band
Rear Seat
Lock
Seat Cushion
Under cover
RH Rear Seat
Reclining Adjuster
Cushion
Seat Leg Cover
Rear No. 1 Seat
Inner Belt
No. 1 Rear Seat
Reclining Cover
Reclining Adjuster
Release Handle
LH Rear Seat
Reclining Adjuster
No. 1 Rear Seat
Reclining Cover
43 (440, 32)
Reclining
Connecting Pipe
42 (430, 31)
37 (380, 27)
37 (380, 27)
N·m (kgf·cm, ft·lbf)
: Specified torque
43 (440, 32)
43 (440, 32)
43 (440, 32)
–
BODY
REAR NO.1 SEAT (Split Type RH)
BO–149
3702
REAR NO.1 SEAT (Split Type RH)
COMPONENTS
BO4SN–01
BO–150
–
BODY
REAR NO.1 SEAT (Split Type RH)
3703
REMOVAL
REMOVE REAR NO.1 SEAT
(a)
Fold the seatback down.
(b)
Unlock the seat lock, and swing the whole seat up and forward.
(c)
Using a screwdriver, remove the seat leg covers.
HINT:
Tape the screwdriver tip before use.
(d)
Remove the 4 bolts and rear No.1 seat.
Torque: 37 N·m (380 kgf·cm, 27 ft·lbf)
BO4SO–01
H17260
H17261
–
BODY
REAR NO.1 SEAT (Split Type RH)
BO–151
3704
DISASSEMBLY
CAUTION:
Wear safety gloves, because the sharp edges and surfaces
of the seat frame may cause injury to the hands.
HINT:
A bolt without a torque specification is shown in the stan-
dard bolt chart (see page
Tape the screwdriver tip before using it to remove the
parts.
1.
REMOVE HEADREST
2.
REMOVE RECLINING ADJUSTER RELEASE HANDLE
3.
REMOVE NO. 1 REAR SEAT RECLINING COVER
(a)
Remove the screw and No. 1 rear seat reclining cover.
(b)
Employ the same manner described above to the other
side.
4.
REMOVE SEATBACK ASSEMBLY
Remove the 4 bolts and seatback assembly.
Torque: 43 N·m (440 kgf·cm, 32 ft·lbf)
5.
REMOVE SEATBACK COVER
(a)
Remove the headrest supports.
(b)
Remove the seatback frame from the seatback cover with
pad.
(c)
Remove the seatback cover from the seatback pad.
6.
REMOVE REAR SEAT CUSHION UNDER COVER
(a)
Remove the screw and cushion.
(b)
Remove the 7 screws and rear seat cushion under cover.
(c)
Remove the screw and fold seat stopper band.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст