Toyota Tundra (2015 year). Manual — part 2159
24. REMOVE DOOR WINDOW REGULATOR BASE PLATE
(for Power Slide Type)
(a) Remove the 3 nuts and door window regulator base plate.
25. REMOVE POWER WINDOW REGULATOR MOTOR
ASSEMBLY (for Power Slide Type)
(a) Using a T25 "TORX" socket, remove the 3 screws and power
window regulator motor.
26. REMOVE BACK WINDOW GLASS
HINT:
Perform these procedures only when replacing the back window glass.
(a) Using a T10 "TORX" driver, remove the screw and stopper (illustration A).
WINDSHIELD / WINDOWGLASS: BACK WINDOW GLASS (for Re...
27. TEMPORARILY REMOVE ROOF HEADLINING ASSEMBLY
(a) for Regular Cab:
so that the back window glass can be removed in a later step.
(b) for Double Cab:
so that the back window glass can be removed in a later step.
28. REMOVE REAR ROOF DRIP SIDE FINISH MOULDING LH
29. REMOVE REAR ROOF DRIP SIDE FINISH MOULDING RH
HINT:
Use the same procedures described for the LH side.
WINDSHIELD / WINDOWGLASS: BACK WINDOW GLASS (for Re...
30. REMOVE BACK WINDOW ASSEMBLY
and back window as shown in the illustration.
(c) Tie objects that can serve as handles (for example, wooden blocks) to both wire ends.
(d) Place matchmarks over the window and vehicle body on the
locations indicated in the illustration.
HINT:
Matchmarks do not need to be placed if the window is not going
to be reused.
(e) Cut through the adhesive by pulling the piano wire around the back window.
NOTICE:
Leave as much adhesive on the vehicle body as possible when removing the back window.
WINDSHIELD / WINDOWGLASS: BACK WINDOW GLASS (for Re...
(f) Using suction cups, remove the back window glass.
NOTICE:
If the stopper is damaged, the back window glass assembly must
be replaced. Be careful when performing the procedure.
31. REMOVE UPPER OUTSIDE BACK WINDOW MOULDING
(for Slide Type, for Power Slide Type)
HINT:
Perform the following procedure if replacing the back window
moulding.
(a) Using a moulding remover, detach the 3 clips and remove the
back window moulding.
32. REMOVE LOWER OUTSIDE BACK WINDOW MOULDING
(for Slide Type, for Power Slide Type)
HINT:
Perform the following procedure if replacing the back window
moulding.
(a) Using a moulding remover, detach the 3 clips and remove the
back window moulding.
33. CLEAN BACK WINDOW ASSEMBLY
(a) Using a scraper, remove the damaged spacers and adhesive sticking to the glass.
NOTICE:
Do not touch the back window surface after cleaning it.
Be careful not to damage the window.
Even if using a new back window, clean the back window with a
non-residue solvent.
WINDSHIELD / WINDOWGLASS: BACK WINDOW GLASS (for Re...
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст