Toyota Tundra (2015 year). Manual — part 2342
Last Modified: 9-16-2014
6.6 A
Doc ID: RM000002ZPW00MX
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: DOOR LOCK: REAR DOOR LOCK (for Double Cab): INSTALLATION; 2015 MY Tundra [08/2014 - ]
INSTALLATION
HINT:
Use the same procedures for the LH side and RH side.
The procedures listed below are for the LH side.
A bolt without a torque specification is shown in the standard bolt chart
.
1. INSTALL REAR DOOR INSIDE LOCKING CABLE ASSEMBLY LH
2. INSTALL REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH
3. INSTALL REAR DOOR LOCK ASSEMBLY LH
4. INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH
5. INSTALL REAR DOOR WINDOW REAR LOWER FRAME SUB-ASSEMBLY LH
6. INSTALL REAR DOOR GLASS RUN LH
7. INSTALL REAR DOOR SERVICE HOLE COVER LH
8. INSTALL REAR NO. 2 DOOR TRIM BRACKET
9. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
10. INSTALL REAR DOOR ARMREST COVER LH
11. INSTALL REAR DOOR FRAME GARNISH LH
12. INSTALL REAR UPPER DOOR ARMREST BASE PANEL LH
13. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH
14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
DOOR LOCK: REAR DOOR LOCK (for Double Cab): INSTALLATION;...
Last Modified: 9-16-2014
6.6 A
Doc ID: RM000001VYU00NX
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: DOOR LOCK: TRANSMITTER BATTERY: REPLACEMENT; 2015 MY Tundra [08/2014 - ]
REPLACEMENT
1. REPLACE TRANSMITTER BATTERY
NOTICE:
Be careful when handling each component as they are precision electronic components.
(a) Insert a precision screwdriver into the gap, and turn the
screwdriver to detach the cover.
HINT:
Tape the screwdriver tip before use.
NOTICE:
Do not forcibly pry up the cover.
(b) Remove the battery (lithium battery: CR2032).
NOTICE:
Do not push the terminals with your finger.
Do not forcibly pry up the battery. The terminals may be
damaged.
Do not touch the battery with wet hands. Water may cause rust.
Do not touch or move any components inside the transmitter, it
may interfere with the proper operation.
When replacing the transmitter battery, before starting work,
remove static electricity that has built up in the body by
touching, for example, the vehicle to prevent the door control
transmitter module set from being damaged.
(c) Install a battery (lithium battery: CR2032) with the positive (+)
side facing upward, as shown in the illustration.
NOTICE:
DOOR LOCK: TRANSMITTER BATTERY: REPLACEMENT; 2015 MY...
Last Modified: 9-16-2014
6.6 K
Doc ID: RM000002ZQ502HX
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: DOOR LOCK: UNLOCK WARNING SWITCH: COMPONENTS; 2015 MY Tundra [08/2014 - ]
COMPONENTS
ILLUSTRATION
DOOR LOCK: UNLOCK WARNING SWITCH: COMPONENTS; 2015 ...
Last Modified: 9-16-2014
6.6 A
Doc ID: RM000002ZQ604JX
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: DOOR LOCK: UNLOCK WARNING SWITCH: REMOVAL; 2015 MY Tundra [08/2014 - ]
REMOVAL
1. REMOVE LOWER STEERING COLUMN COVER (for Manual Tilt)
2. REMOVE UPPER STEERING COLUMN COVER (for Manual Tilt)
3. REMOVE LOWER STEERING COLUMN COVER (for Manual Tilt and Manual Telescopic
Steering Column)
4. REMOVE UPPER STEERING COLUMN COVER (for Manual Tilt and Manual Telescopic
Steering Column)
5. REMOVE LOWER STEERING COLUMN COVER (for Power Tilt and Power Telescopic
Steering Column)
6. REMOVE UPPER STEERING COLUMN COVER (for Power Tilt and Power Telescopic
Steering Column)
7. REMOVE UNLOCK WARNING SWITCH ASSEMBLY
(a) Disconnect the connector.
(b) Insert the key.
(c) Remove the unlock warning switch assembly by releasing the 2 claws.
HINT:
Slide the unlock warning switch assembly in the direction shown by the arrow in the illustration to remove
it.
Text in Illustration
Slide
DOOR LOCK: UNLOCK WARNING SWITCH: REMOVAL; 2015 MY T...
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст