Toyota Tundra (2015 year). Manual — part 2407
Last Modified: 9-16-2014
6.6 A
Doc ID: RM000002VWV00DX
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: LIGHTING: FRONT DOOR COURTESY SWITCH: INSTALLATION; 2015 MY Tundra [08/2014 - ]
INSTALLATION
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
A bolt without a torque specification is shown in the standard bolt chart
.
1. INSTALL FRONT DOOR COURTESY SWITCH
(a) Connect the connector.
(b) Using a T30 "TORX" socket wrench, install the front door courtesy switch with the screw.
LIGHTING: FRONT DOOR COURTESY SWITCH: INSTALLATION; 20...
Last Modified: 9-16-2014
6.6 K
Doc ID: RM000002YFN00IX
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: LIGHTING: IGNITION KEY CYLINDER LIGHT: COMPONENTS; 2015 MY Tundra [08/2014 - ]
COMPONENTS
ILLUSTRATION
LIGHTING: IGNITION KEY CYLINDER LIGHT: COMPONENTS; 201...
Last Modified: 9-16-2014
6.6 A
Doc ID: RM000002YFO00KX
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: LIGHTING: IGNITION KEY CYLINDER LIGHT: REMOVAL; 2015 MY Tundra [08/2014 - ]
REMOVAL
1. REMOVE LOWER STEERING COLUMN COVER
(a) for Manual Tilt:
(b) for Manual Tilt and Manual Telescopic Steering Column:
(c) for Power Tilt and Power Telescopic Steering Column:
2. REMOVE UPPER STEERING COLUMN COVER
(a) for Manual Tilt:
(b) for Manual Tilt and Manual Telescopic Steering Column:
(c) for Power Tilt and Power Telescopic Steering Column:
3. REMOVE TRANSPONDER KEY AMPLIFIER (IGNITION
KEY CYLINDER LIGHT)
(a) Disconnect the unlock warning switch connector.
Text in Illustration
*1
Unlock Warning Switch Connector
(b) Detach the 2 claws.
(c) Disconnect the connector and remove the transponder key
amplifier (ignition key cylinder light).
LIGHTING: IGNITION KEY CYLINDER LIGHT: REMOVAL; 2015 MY...
Last Modified: 9-16-2014
6.6 G
Doc ID: RM000002YFM009X
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: LIGHTING: IGNITION KEY CYLINDER LIGHT: INSPECTION; 2015 MY Tundra [08/2014 - ]
INSPECTION
1. INSPECT TRANSPONDER KEY AMPLIFIER (IGNITION
KEY CYLINDER LIGHT)
(a) Apply battery voltage to the connector and check the light
illumination condition.
OK:
CONDITION
SPECIFIED CONDITION
Battery positive (+) → Terminal 2 (ILL+)
Battery negative (-) → Terminal 6 (ILL-)
Illuminates
If the result is not as specified, replace the transponder key
amplifier (ignition key cylinder light).
Text in Illustration
*a
Component without harness connected
(Transponder Key Amplifier (Ignition Key Cylinder Light))
LIGHTING: IGNITION KEY CYLINDER LIGHT: INSPECTION; 2015 ...
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст