Toyota Tundra (2015 year). Manual — part 2927
EXTERIOR: ROOF DRIP SIDE FINISH MOULDING: COMPONENT...
Last Modified: 9-16-2014
6.6 A
Doc ID: RM000002W7M00BX
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: EXTERIOR: ROOF DRIP SIDE FINISH MOULDING: REMOVAL; 2015 MY Tundra [08/2014 - ]
REMOVAL
HINT:
Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
When removing the moulding, heat the vehicle body and moulding using a heat light.
When replacing a clip, heat the vehicle body and clip using a heat light.
Standard heating temperature:
ITEM
TEMPERATURE
Vehicle Body
40 to 60°C (104 to 140°F)
Moulding
20 to 30°C (68 to 86°F)
Clip
20 to 30°C (68 to 86°F)
NOTICE:
Do not heat the vehicle body, moulding and clip excessively.
1. REMOVE REAR ROOF DRIP SIDE FINISH MOULDING LH
(a) Put protective tape around the moulding.
(b) Using a heat light, heat the moulding.
NOTICE:
Do not heat the moulding and vehicle body excessively.
(c) Using a moulding remover, detach the clip and remove the
moulding.
NOTICE:
Do not remove the clip from the vehicle body.
If the clip is damaged or removed accidentally, replace it.
2. REMOVE ROOF DRIP SIDE FINISH MOULDING LH
(a) Put protective tape around the moulding.
(b) Using a moulding remover, detach the clip and remove the moulding.
NOTICE:
Do not remove the clip from the vehicle body.
If the clip is damaged or removed accidentally, replace it.
EXTERIOR: ROOF DRIP SIDE FINISH MOULDING: REMOVAL; 20...
3. REMOVE ROOF DRIP SIDE FINISH MOULDING CLIP
HINT:
Perform the following procedure only if the clips are damaged or have come off the vehicle.
EXTERIOR: ROOF DRIP SIDE FINISH MOULDING: REMOVAL; 20...
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст