Toyota Tundra (2015 year). Manual — part 2928
Last Modified: 9-16-2014
6.6 A
Doc ID: RM000002W7K00BX
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: EXTERIOR: ROOF DRIP SIDE FINISH MOULDING: INSTALLATION; 2015 MY Tundra [08/2014 - ]
INSTALLATION
HINT:
Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
When installing a clip, heat the vehicle body and clip using a heat light.
When installing the moulding, heat the vehicle body and moulding using a heat light.
Standard heating temperature:
ITEM
TEMPERATURE
Vehicle Body
40 to 60°C (104 to 140°F)
Moulding
20 to 30°C (68 to 86°F)
Clip
20 to 30°C (68 to 86°F)
NOTICE:
Do not heat the vehicle body, moulding and clip excessively.
1. INSTALL ROOF DRIP SIDE FINISH MOULDING CLIP
HINT:
Perform this procedure only when installing new clips.
(a) Using a heat light, heat the clip installation areas on the vehicle body.
(b) Remove the double-sided tape from the vehicle body.
(c) Wipe off any tape adhesive residue with cleaner.
(d) Using a heat light, heat the clips.
After removing the peeling paper, keep the exposed adhesive free from foreign matter.
(f) Install the clips in the positions shown in the illustration.
HINT:
Press the clips firmly to install them.
EXTERIOR: ROOF DRIP SIDE FINISH MOULDING: INSTALLATIO...
2. INSTALL ROOF DRIP SIDE FINISH MOULDING LH
(a) Attach the clip to install the moulding.
EXTERIOR: ROOF DRIP SIDE FINISH MOULDING: INSTALLATIO...
3. INSTALL REAR ROOF DRIP SIDE FINISH MOULDING LH
(a) Clean the vehicle body surface.
(1) Using a heat light, heat the vehicle body surface.
(2) Remove the double-sided tape from the vehicle body.
(3) Wipe off any tape adhesive residue with cleaner.
(b) If reusing the moulding:
Clean the moulding.
(1) Using a heat light, heat the moulding.
(2) Remove the double-sided tape from the moulding.
(3) Wipe off any tape adhesive residue with cleaner.
EXTERIOR: ROOF DRIP SIDE FINISH MOULDING: INSTALLATIO...
(4) Apply new double-sided tape to the moulding, as shown in
the illustration.
(c) Install the moulding.
(1) Using a heat light, heat the vehicle body and moulding.
After removing the peeling paper, keep the exposed adhesive free from foreign matter.
(3) Attach the clip to install the moulding.
HINT:
Press the moulding firmly to install it.
EXTERIOR: ROOF DRIP SIDE FINISH MOULDING: INSTALLATIO...
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст