Toyota Tundra (2015 year). Manual — part 511
4. REMOVE NO. 2 POSITION INDICATOR SLIDE COVER
(a) Remove the No. 2 position indicator slide cover from the
position indicator slide cover.
5. DISCONNECT INDICATOR LIGHT WIRE SUB-ASSEMBLY
(a) Using a thin-bladed screwdriver, release the connector housing
retainer.
Text in Illustration
*1
Connector Housing Retainer
*a
Component without harness connected
(Transmission Control Switch)
(b) Using a thin-bladed screwdriver, pull out the 4 (ILL+) and 8 (ILL-) terminals from the rear as shown in the
illustration.
(c) Detach the 4 guides from the shift lever assembly.
6. REMOVE LOWER POSITION INDICATOR HOUSING
A760F AUTOMATIC TRANSMISSION: SHIFT LEVER ASSEMBLY (...
(a) Using a small screwdriver, detach the 4 claws and remove the
lower position indicator housing from the shift lever assembly.
Text in Illustration
*a
Protective Tape
NOTICE:
Be careful not to damage the lower position indicator housing
and shift lever assembly.
HINT:
Tape the screwdriver tip before use.
7. REMOVE INDICATOR LIGHT WIRE SUB-ASSEMBLY
(a) Disconnect the connector and remove the indicator light wire
sub-assembly from the lower position indicator housing.
8. REMOVE POSITION INDICATOR LED
(a) Detach the claw and remove the position indicator LED from the
lower position indicator housing.
9. REMOVE SHIFT LOCK CONTROL ECU
A760F AUTOMATIC TRANSMISSION: SHIFT LEVER ASSEMBLY (...
(a) Disconnect the shift lock solenoid connector.
(b) Detach the 3 claws and remove the shift lock control ECU from the shift lever assembly.
A760F AUTOMATIC TRANSMISSION: SHIFT LEVER ASSEMBLY (...
Last Modified: 9-16-2014
6.6 G
Doc ID: RM0000030G604QX
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: A760F AUTOMATIC TRANSMISSION: SHIFT LEVER ASSEMBLY (for Floor Shift Type): INSPECTION; 2015
MY Tundra [08/2014 - ]
INSPECTION
1. INSPECT TRANSMISSION CONTROL SWITCH
(a) Disconnect the transmission control switch connector.
(b) Measure the resistance according to the value(s) in the table
below.
Standard Resistance:
TESTER
CONNECTION
CONDITION
SPECIFIED
CONDITION
3 (IG) - 7 (S)
Shift lever in S, "+" or "- "
Below 1 Ω
2 (SFTU) - 5 (E)
Shift lever held in "+"
(Up-shift)
1 (SFTD) - 5 (E)
Shift lever held in "-"
(Down-shift)
3 (IG) - 7 (S)
Shift lever not in S, "+" or
"-"
10 kΩ or higher
2 (SFTU) - 5 (E)
Shift lever in S
1 (SFTD) - 5 (E)
If the result is not as specified, replace the transmission floor
shift assembly.
A760F AUTOMATIC TRANSMISSION: SHIFT LEVER ASSEMBLY (...
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст