Toyota Tundra (2015 year). Manual — part 1197
OK
-
EGR STEP POSITION (ACTIVE TEST)
0 STEPS
0 TO 30 STEPS
MAP
(Data List)
20 to 40 kPa (150 to 300
mmHg)
MAP value is at least +10 kPa (75 mmHg) higher than when EGR
valve is fully closed
OK
GO TO STEP 19
NG
GO TO STEP 5
5.
INSPECT EGR VALVE ASSEMBLY
(a) Remove the EGR valve
.
(b) Check if the EGR valve is stuck open.
OK:
EGR valve is tightly closed.
OK
GO TO STEP 19
NG
GO TO STEP 17
6.
REPAIR OR REPLACE THROTTLE WITH MOTOR BODY ASSEMBLY
(a) Repair or replace the throttle with motor body assembly
.
HINT:
Perform "Inspection After Repair" after repairing or replacing the throttle with motor body assembly
.
NEXT
GO TO STEP 19
7.
CHECK PCV HOSE
(a) Check the PCV hose connections
.
OK:
PCV hose is connected correctly and is not damaged.
NG
GO TO STEP 14
1UR-FE ENGINE CONTROL SYSTEM: SFI SYSTEM: P050B; Cold St...
OK
OK
8.
CHECK INTAKE SYSTEM
(a) Check the intake system for vacuum leaks
.
OK:
No leak in the intake system.
HINT:
Perform "Inspection After Repair" after repairing or replacing the intake system
.
NG
GO TO STEP 15
9.
INSPECT AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
(a) Visually check that the air cleaner filter element sub-assembly is not excessively contaminated with
dirt or oil.
OK:
The air cleaner filter element sub-assembly is not excessively contaminated with dirt or oil.
NG
GO TO STEP 16
10.
PERFORM ACTIVE TEST USING TECHSTREAM (CONTROL THE EGR STEP POSITION)
(a) Connect the Techstream to the DLC3.
(b) Start the engine and warm it up until the engine coolant temperature reaches 75°C (167°F) or
higher.
HINT:
When performing the Active Test, make sure the shift lever is in P or N.
The A/C switch and all accessory switches should be off.
(c) Turn the Techstream on.
(d) Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the EGR Step
Position.
(e) Confirm the Throttle Idle Position is ON and check the engine idling condition and MAP values in the
1UR-FE ENGINE CONTROL SYSTEM: SFI SYSTEM: P050B; Cold St...
OK
Data List while performing the Active Test.
HINT:
Do not leave the EGR valve open for 10 seconds or more during the Active Test.
Be sure to return the EGR valve to step 0 when the Active Test is completed.
OK:
MAP and idling condition change in response to EGR step position as follows.
Standard:
-
EGR STEP POSITION (ACTIVE TEST)
0 STEPS
0 TO 30 STEPS
Idling
condition
Steady idling
Idling changes from steady to rough idling or engine stall
MAP
(Data List)
20 to 40 kPa (150 to 300
mmHg)
MAP value is at least +10 kPa (75 mmHg) higher than when EGR
valve is fully closed
OK
GO TO STEP 12
NG
GO TO STEP 11
11.
INSPECT EGR VALVE ASSEMBLY
(a) Remove the EGR valve assembly
.
(b) Check if the EGR valve is stuck open.
OK:
EGR valve is tightly closed.
NG
GO TO STEP 17
12.
PERFORM ACTIVE TEST USING TECHSTREAM
(a) Operate the VVT system through the Active test, and check if the VVT system is operating normally.
(1) Perform the Active Test, referring to DTC P0011 inspection procedure (VVT system for intake side)
.
(2) Perform the Active Test, referring to DTC P0014 inspection procedure (VVT system for exhaust
side)
.
NG
GO TO STEP 18
1UR-FE ENGINE CONTROL SYSTEM: SFI SYSTEM: P050B; Cold St...
OK
13.
READ VALUE USING TECHSTREAM (MAF)
(a) Connect the Techstream to the DLC3.
(b) Start the engine and turn the Techstream on.
(c) Enter the following menus: Powertrain / Engine and ECT / Data List / MAF and Coolant Temp.
(d) Allow the engine to idle until Coolant Temp reaches 75°C (167°F) or higher.
(e) Read MAF with the engine speed at 3000 rpm.
Standard:
Between 18.3 gm/sec. and 25.8 gm/sec. (shift lever: N; A/C: Off)
OK
GO TO STEP 19
NG
GO TO STEP 20
14.
REPAIR OR REPLACE PCV HOSE
(a) Repair or replace the PCV hose.
NEXT
GO TO STEP 19
15.
REPAIR OR REPLACE INTAKE SYSTEM
(a) Repair or replace the intake system.
HINT:
Perform "Inspection After Repair" after repairing or replacing the intake system
.
NEXT
GO TO STEP 19
16.
REPLACE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
(a) Replace the air cleaner filter element sub-assembly.
NEXT
GO TO STEP 19
1UR-FE ENGINE CONTROL SYSTEM: SFI SYSTEM: P050B; Cold St...
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст