Toyota Tundra (2015 year). Manual — part 2363
OK
OK
(a) Remove the unlock warning switch
.
(b) Measure the resistance according to the value(s) in the
table below.
Standard resistance:
TESTER CONNECTION SWITCH CONDITION SPECIFIED CONDITION
1 - 2
Switch is pushed
Below 1 Ω
Switch is not pushed
10 kΩ or higher
NG
REPLACE UNLOCK WARNING SWITCH
5.
CHECK HARNESS AND CONNECTOR (UNLOCK WARNING SWITCH - BODY GROUND)
(a) Disconnect the J18 switch connector.
(b) Measure the resistance according to the value(s) in the
table below.
Standard resistance:
TESTER CONNECTION
CONDITION
SPECIFIED CONDITION
J18-2 - Body ground
Always
Below 1 Ω
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
ENGINE IMMOBILISER: ENGINE IMMOBILISER SYSTEM: B2780; P...
6.
CHECK HARNESS AND CONNECTOR (UNLOCK WARNING SWITCH - TRANSPONDER
KEY ECU)
(a) Disconnect the J18 switch connector.
(b) Disconnect the J26 ECU connector.
(c) Measure the resistance according to the value(s) in the table
below.
Standard resistance:
TESTER CONNECTION
CONDITION
SPECIFIED
CONDITION
J26-3 (KSW) - J18-1
Always
Below 1 Ω
J26-3 (KSW) or J18-1 - Body
ground
Always
10 kΩ or higher
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
REPLACE TRANSPONDER KEY ECU
ENGINE IMMOBILISER: ENGINE IMMOBILISER SYSTEM: B2780; P...
Last Modified: 9-16-2014
6.6 C
Doc ID: RM000001TCN03PX
Model Year: 2015
Model: Tundra
Prod Date Range: [08/2014 - ]
Title: ENGINE IMMOBILISER: ENGINE IMMOBILISER SYSTEM: B2784; Antenna Coil Open / Short; 2015 MY
Tundra [08/2014 - ]
DTC
B2784
Antenna Coil Open / Short
DESCRIPTION
The antenna coil receives key code signals from the transponder chip in the key grip. The coil is built into the
transponder key amplifier, which amplifies the key code signals and outputs the signals to the transponder key
ECU.
This DTC is output when there is an open or short malfunction in the antenna coil.
DTC CODE
DTC DETECTION CONDITION
TROUBLE AREA
B2784
Antenna coil is open/shorted
Harness or connector
Transponder key ECU
Transponder key amplifier
WIRING DIAGRAM
ENGINE IMMOBILISER: ENGINE IMMOBILISER SYSTEM: B2784; A...
NEXT
INSPECTION PROCEDURE
HINT:
When the transponder key ECU is replaced, reregister the ECU - ECM communication ID
.
PROCEDURE
1.
CLEAR DTC
(a) Clear the DTC
.
2.
CHECK FOR DTC
(a) Check for DTC
.
OK:
ENGINE IMMOBILISER: ENGINE IMMOBILISER SYSTEM: B2784; A...
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст